wOOp.
Having not used a soldering iron for about 8 years, took me 4-5 hours on and off =(
Had to run out and buy some proper snips, as my pliers were old and rusty.
Had a bit of issue with the regulator/transitor things bridging leads. Didnt have a solder sucker, so was a bit of grief there.
Also the yellow led photo, orientation is wrong, so i ended up swapping red & yellow. Only noticed next photo on that yellow was wrong corner. No marking on the actual board either.
Finally the actual consult plug had me a little stumped. Wasnt sure what flaps needed to be folded etc, so ended up cutting them all off =p
Also no indication of how far to pull the pins through. Originally had the silver pins flush with the back (1/4 of the depth), but then pulled them through with pliers about half way through the plug.
Not having a dig at newkleer, just bringing up some problems i had hung over this afternoon, so others know what to look for.
Next event was to find a laptop to test with. My friend wouldnt let me use his moms brand new one (fear of blowing things up), so ended up wiht some ancient pentium. Tested using free conzult as it fits on a floppy.
Came up straight away without any issues, so was over the moon. Didnt want to get my hopes up in case things didnt work. Only hitch right now, is the battery only lasts a few minutes, so no road trips yet.
Oh, if anyone can explain the base idle menu in free conzult. has a yellow bar, with green band in the middle. Shows CMPS vs RPM (cam position sensor vs rpm). My R33 is doing 680 which is just below the green band. Wondering if it is intended for 300zx motor.