sky30

Anyone else??

Have bled it, no air, it has a good feel to it 9not spongy)

I have a Heavy duty single plate clutch in my R32 skyline, when my engine is cold the clutch will release with the pedal about half way out (were i want it), then after driving my car for a while when my engine/driveline heats up, the clutch will relaese right at the top of the pedal. Does anyone else have this problem, anyone know what causes this, and how to fix so its the same when hot and cold, my previous R32 didnt have this problem??

As CEFFY SA said, its probly the wastegate flap not sealing tight. i also had this problem, just grab the actuator rod with pliers and use a big screwdriver to put a bend in the middle, this will pull the gate flap shut tighter and fix the problem. Takes like 1 minute to do and makes the car feel so much better to come on boost.

So you have done the upgrade as a befroe and after on the same engine without other mods? 50rwhp gain? How much extra lag we talking in RPM to make full boost?

bump

bump

] What fuel pump, and what base rail pressure you using?

Has anyone seen or heard of the results of upgrading the compressor wheel to the to4z item, compared to a GT35??? Im looking to max out my GT35 (.82 turbine) soon, currently makes 510rwhp on 17.5psi, can anyone confirm the upgrade works?

Yeah, im also wondering if std lines will support 700bhp??

Yep, got the tools,no dramas Ash. You get a tune yet?

I might put mine on if im not working.

I will consider it if i cant sell locally.

Dont have any pics of it on the car sorry.

Will consider post interestate at buyers expense.

Thanks Micheal, Its just that on the back of the box they give 3 differnt torques for 3 different tensiles, but how do you know what tensile you got, then in the box they put a paper that says 70ftlb i think.

Exhaust technology 3" mandrel bent exhaust from cat converter to rear with twin JunBL stainless mufflers. Made in adelaide by exaust technology. Was on a R32 skyline, possibly fit R33. $330 O.N.O

Exhaust technology 3" mandrel bent exhaust from cat converter to rear with twin JunBL stainless mufflers. Made in adelaide by exaust technology. Was on a R32 skyline, possibly fit R33. $330 O.N.O PM me.

Anyone else??

Yes it fits the std turbo, and bolts up to the std cat converter.

Mild steel with some sort of coating/paint i think.

Tried to put this in the S.A. for sale section, but ended up here??

I have a dump pipe that goes off the back of the turbo all the way to the cat converter In 3" mandral bent, came off my R32, may fit R33 also (not 100% sure). In very good condition, near new. $120 ONO PM me. Cheers

70ftlb is less thhan std?? Anyone else??

What do i torque 11mm RB20/RB25 ARP head studs to ?? Also whan people have installed these have they used 2 washers per stud? I heard they are a little bit too long and the thread bottoms out with only 1 washer. Cheers