itbmils

pps I have a set of wheels that I need to have 'restored' just gutter rash - and I'm considering a colour change too I need somewhere on the sth side of Brisy - any suggestions pls TYIA Scott

can I be the first to ask what (if anything) you are planning on doing with the internals ? 1.4 bar sounds like too much boost for std internals to me (shrugs) - any other comments Also - walbro are WAY too loud for me - even in tank drives me crazy just my 2c worth

do you still have this block? keen as

you have PM interested in the block only

Hey MR RB30 I'm keen - you have PM

still for sale ?

OK pps I'm interested in anyone that has a RB26 short motor for sale will pay fair price for the right set up - can look at any build spec. would prefer fully rebuilt with forged internals - but also open to suggestions want to drop straight into my R32 GTR talk to me !!!

and b4 u ask - yes I still want the bonnet

wife filled car from budget provider - did not tell me until I asked !!! I had the engine done over 3 years ago no (don't drive it much) - has not missed a beat - until now Annyyywaaayyy any advice on what to do ? I'm very tempted to just replace the bigends and leave it at that - comments ?

already @ workshop combination of heat and bad fuel thermo fan popped a fuse while I was in bumper to bumper traffic - and I was not running PULP !!!

OK pps seems the weapon has developed a rattle coming from pot number 4/5 My mechanic is telling me it's the big ends The engine is still quite new - only 20,000klms since full rebuild - so what should I do just replace the big ends (rechecking the crank) - or should a more complete build be considered ? Also - pointers on what bearings to use this time around - I used Race Pace last time I think ??

Hi Matt u still got these - and is this price for all four corners ?

Guys I'm in need of new pads and rotors for all four corners of my R32 GTR the front rotors are down to the 30mm limit I'm told and the rears are not too much better So What should I be looking at (DBAs) for the rotors What pads should I run for daily driver use Where is the best (cheapest) place to get this stuff (have not checked the GB section yet ) TYIA Scott

I'm looking at swapping to CF bonnet - so have a GMG GTR bonnet in good shape (1 minor scratch) has bonnet pin holes already drilled

will these fit an R32 GTR ?