r33gtst196

put me down for 1 thanks

I am in also if i can get one on my door for $600 but when will this happen???

have you got any pics and will you post to Gosford NSW $$$

sounds good

Can any one send me some info or pics of intercoolers fitted without removing the aircon fan and moding the bonnet latch support thanks

There is a air bleed bolt at the front of the intake manafold Remove radiator cap put funnel in hole fill with water then remove bolt until all the air comes out then replace the bolt this will remove the air lock good luck

I removed the pocket got a sheet of 2 mm alloy and mark around the pocket fold it so that you have the two sides long enough so that you can use the factory holes in the Brackets drill the holes for ya gauges you will find that you need to make the holes about 2-3mm up from the centre because the lower part of the pocket sits behind the console. Start polishing it will look like stainless steel when done if ya want I will get some pics this week but will not have time to pull it all out to take other pics atm Also if you are upping the boost I would get a air/fuel gauge rather than the oil temp ( it uses pin 29 on the ECU) good luck

Motul is distrubited by link in aus give them a call or www.motul.com.au LINK INTERNATIONAL PTY LTD 1 Emeri Street, Stapylton, QLD 4207 PO Box 1165, Beenleigh, QLD 4207 Ph: +61-7-3382 5000 Fax: +61-7-3382 5050 Fax Order: 07 3807 2100 Toll Free: 1800 777 958 (Australia only)

are both the frount wheels gutter surfed what brand rubber is on them very keen

Is anyone interested in a wrx interior Black and red I have front and rear seats all excellent condition will bolt into most subarus or mod rails for skyline $1200 ono PM me if Interested

I picked up my r33 gtst from the dealer it was back there that week due to 1st to 2nd gear crunchey and the shifter moveing up and down in 2nd they put the redline in it has now been 5000ks and its getting better all the time also the 2nd gear syncro is going to die first and you can not replace case hardend steel or brass with oil it will mask the prob for a bit

Will you take $800 for the pfc this seems to be the going rate for a second hand one thanks

I did this mod (Black wire from solenoid to ground and it works sick boots hits 7-8 PSI at 3000RPM instead of 4500 could be fun in the wet Also I have a fuel air gauge and there is no sign of lean out after doing this mod If any one is interested pm me and I will look up info on tapping into the wire at the computer to Make it easy to put in a switch in the car

Can you still get the shifters?? please pm me the info thanks

the cruize today was great. it was good to see everyone pay their respects. and i hope you all drive safely

I know this bulk buy is closed but is there any chance of getting one will pay by yesterday if ok please let me know R33 gtst 1st 96 series II Ph 0411982090 thank you

do you still have the power fc???

Will you take $200???