CeffyNSW

Thanks for the response BLITZ Think they will want more than I want to pay. Hoping to find someone who has, or is going to remove a set to put in racing seats.... and just have them lying around

Guys At last, the auto is on its way out! Can some one describe the step by step requirements around the electricals so that it will run? Thanks

Guys After front seats for my Ceffy. Thanks

Guys I went and saw OBK and the yong guy there was talking positively about Cefiro kits, even showed me where they were up to. The next week I went back and they told me they were closing down as they could not compete with the cheap imports!

Guys OBK are right near where I work, so will be dropping in real soon! Also tried D1 Garage in SA, they are waiting on their supplier to get into the Cefiro game, no real time frame though!

They are all the same Pull off the caliper, pull off the disc and you will find the inside of the disc is the drum for the handbrake. You will see the shoes there.

Have been looking myself. currently talking to Garage-13, not sure how that will go.

Thanks, guys Have contacted RiverSide Mr Eps, will be working this out next week, let you know if I need them Regards

Guys Took mine off as I didn't like them, so have 2 sets if someone wants them. My rubbers in this area are quite poor.

Thanks, Mr Eps What type are they, early or late model? How much would it cost to send them across? Guys, what if I wanted a different rear bumper (ie body kit type), where would I get one and how much? Thanks

Guys Got rear ended today, not happy Jan! Ceffy is OK but will need parts and repairs. Might need some parts, depending how it all works out, so anybody got spare tail lights, boot and rear bar? Thanks

Cef33y If you want to sell, I might be interested.

Thanks for all the advice guys. Sounds like R32 is great, R33 a little better!

Thanks, Guys So you wouldn't go to the R33 (300mm rotor diameter) set up? Assume would fit straight on also? Would it make much difference? Bigger rotor and probably thicker, calipers?

Hi guys If eventually I want to go to RB25, what brake set up is the minimum? Ie will R32 be OK with 280mm rotos and 4 spot calipers on the front?

Thanks, will give it a go

Thanks for the comments guys C_DawG using R32 handbrake also? Suppose photos would not show much? Thanks

Guys All I need is a hand brake and I have everything for an auto to manual conversion. Am getting differing views on how to achieve this some say R32 some say S13 and what about the console? Ideally would like it as tidy as possible, funnily enough, can not find anybody willing to give up a Ceffy hand brake and console. don't suppose naybody imports them! Have seen pictures of Ceffy with auto console cut out with ??? hand brake. So come on guys, 80% of you must have done this, what is the best fit? Then I will have an auto box to donate to those in need, or should I just beat it with a stick!? Thanks

Have you tried Mr Mag in Perth? They import lots of wheel. Regards

Diduc I have 2 of these, 4 stud and have been looking for another 2. Are yours 4 stud?

Thanks Too Much Too Boost It is not good news, but I am getting there too!

Thanks pitchd Went and checked locally today, close but not close enough Will keep looking.

Hi Guys Think I have the only Ceffy in Wollongong! Have JIC coil overs on rear and one of them is noisy. Believe it is from the caster top, so have pulled it apart and took the "bearing" to bearing shop and asked for a replacement, with no luck! Can anybody suggest where I can get a replacement? Thanks

Oosh No longer interested interested

Oosh Am still thinking, very slow, checking prices of rebuild verus short motor. Will be in Melbourne after xmas. Would want to check condition of crank.