NCred02
-
Posts
53 -
Joined
-
Last visited
-
Feedback
0%
Content Type
Profiles
Forums
Events
Gallery
Media Demo
Store
Everything posted by NCred02
-
The tension rod bushings are toast
-
Oil? There's oil in there?
-
Appointment with a chassis shop made. I looked , twisted, pulled, measured and I cant see anything, but I'm no specialist appreciate the replies
-
My Passengers side wheel is a 1/2" or 12mm further back towards to rear of the car. I dont what I'm looking at but there does not seem to be any adjustment for caster. Anyone have this issue? Or how to check which bushing? 93 r32
-
-
I'm in need of the bracket for the air door actuator located on the driver's side. I have the motor but no bracket R32 rb20det
-
Ok. That makes sense. Thank you
-
Traced this wire from behind the radio console to the ECU. it's tapped into the yellow with green strip wire. Label translation is " vehicle speed pulse " Any clues would be appreciated. Still searching on way my fuel consumption is really bad
-
Thank you
-
Kudo? You have a part number by chance?
-
Ive been searching for an O2 sensor and lots of conflicting information so I thought I'd ask here Getting horrible gas mileage and going to try this first. Anyone have any information on an aftermarket or OEM? 93GTST RB20DET
-
east coast?
-
just about everything is 10mm.... You should find lots of places that are missing screws/clips be ready to draw some attention. at first it was fun and now its a pita Seriously, take your time. I'm learning patience has value $$$.
-
Any clue what this clear tube does? I have searched and cant find anything. Took seats out to fab the piece that is missing in the trunk wall. Shown here on the left
-
Edited from above post
-
So if I understand. A RB20 turbo compressor outlet and a RB25 are not the same size? Excuse my lack of knowledge. never had a turbo and my first Japanese vehicle as well. I have searched for outlet specs and cant find any information on bolt pattern or spacing
-
This is the spacing I need . Bolts are 58mm apart. Is this standard RB25 dimensions?
-
Hole spacing is 54mm. I need 58mm
-
Does anyone know if the RB20 and RB25 are the same? MyRB20 pipe is just a bit smaller than the turbo out let. Bolts dont line up and opening is different size. My turbo is "direct fit" aftermarket and theres been a few snags. Any ideas on how to get this done or where to find one would be appreciated. Can I bore out the old one? widen the hole spread?
-
Thanks Chris. Will do
-
Rb20Det Heater Hose Diagrams With Nissan Part Numbers
NCred02 replied to HYBR3D's topic in General Maintenance
awesome diagram -
I want to replace every inch of line I can as 30 years takes it toll. But I can't get behind the block, between the firewall and the engine to disconnect them.
-
The direct replacement is not that direct. My issue is the coolant intake on the original is bigger than the opening for the new one. So I need to go from a hardline ,5/16, to the braided threads , 9/16- 18. Any ideas? Cant find anything
-
In the middle of the rb25 upgrade on the rb20. Its actually a Arashi bolt on. Its in and lined up perfect First question is can I use a standard hose as my oil return line? New turbo fitting is shorter and having to change the line/hose The oil supply/intake hose has a smaller hole than stock. Not sure I should go back with the old one Any other tips would be appreciated
-
Passenger Door not closing all the way
NCred02 replied to NCred02's topic in R Series (R30, R31, R32, R33, R34)
I believe so. That door is original but seems to have been messed with
