So, this is basically me, giving up and asking for help. I'm truly stumped what's going on with this car. I've had this car for almost a year (R33 GTST, S2 Engine) and it's always had a mild misfire on idle. Always drove fine so was never a huge bother, but I did try a few things to no avail. Again, only mild and on idle, so not a real worry. I have replaced basically everything on it:
Injectors,turbo,manifold gaskets,sump,fuel rail,plenum etc. Basically all bolt ons are new. Engine was out of the car but not torn down. Should have but ran out of time. Anyway, basically every and all gaskets are new, same with belts etc.
Running an APEXI PFC tuned on a MAF sensor. Making ~300RWKW.
Recently, the misfire has now moved up to being rather suddenly worse (within the space of a few days/weeks) and now the car runs oddly rich at 9:1 under boost and misfires everywhere. Used to be around 11:1 or so. The idle is very lean at 16-17:1 and bounces between 850 and 1000 RPM. Runs awful, backfires all through the rev range and is not safe to drive.
When I unplug the cylinder 1 coil or injector, the idle barely changes compared to the other 5 cylinders. IT DOES THIS RANDOMLY- sometimes it will make a decent idle change then most of the time it won't change idle at all. Since then, i've checked or replaced all of these items with very little improvement.
- Swapped injector and coil to another cylinder seperately- STAYED ON CYLINDER 1? All other 5 cylinders make changes to idle when either coil or injector are unplugged. Cylinder 1 barely makes any at all, most of the time none.
- Compression tested: All cylinders, WOT, warm engine, plugs out..... = 125 PSI across all 6 give or take 3-4PSI. Slightly lower than expected but very even. Done on 2 of the same compression testers for reference. No smoke, no blowby in catch can, seems fine.
- Known working coils put in
- Known good coil loom in
- Voltage tested injector loom and resistance tested injectors themselves, 12v on both sides when placed multimeter grounded with chassis. Was saying 6Volts for a bit but then it went to 12, and i'm not sure why.
- CAS swapped out for a test
- MAF cleaned, car dies when unplugged. Had no issues with MAF tuning the car either.
- ECU wiring looks a bit piss poor but nothing seems loose or damaged.
- Regrounded engine block to chassis
- Changed plugs, lowered gap to 0.7mm (BCP7ES I believe?) but these were brand new plugs swapped for brand new plugs anyway.
Sorry for the long post, but i'm totally stumped where to go from here. This small misfire has suddenly gone big and i've done heaps to figure it out. Now hopefully someone can help.
Rant over- all help appreciated