VLCALAIS11

Hey all i need to get hold of a 17 inch enkei 5 spoke rim if u have any can u send me some photos so i can see if they are the same, thanks lars

Hey mate could u ring of the wreckers over your way and find out who the use and what its worth? Thanks lars

Pm's sent, i dont want to spend anymore than 2500

Hi i need a Rb25det complete motor with accesories or not must be working and in good condition. I am located in bundaberg so it will need to be transported. Thanks lars

Hey all i just come on here i would like to know how much power a complete standard RB30NA piston and rings will hold i know the bottom ends are pretty bomb proof so im not worried about that, i read like 7 pages of the sticky thread where the question is bought up initally and then at least 2/3 other times and on one has seemed to write an around about figure, i tried some of the links that apparently have the answers but they wont work for me. I have a RB30et bottom end rebuilt with forgies in it and a RB25DET vvt head since reading on here i have found that if i combind these too i will be left with a crazy 7.1:1 CP which i dont want due to street driveablity, and as yet i have found no way to combat this CP problem so i think i will just go with the standard RB30NA bottom end which should give me around 8.5:1 which should be good, or maybe even shave the head to get me near 9.1:1 i just need to know how much power the RB30 na pistons and rings will hold. Also will an Apexi Power FC run this hybrid motor happily? ANY HELP WOULD BE GREATLY APPRECIATED. Thank you for ur time Lars

hey all i was just wondering where i could get hold of a R33 wiring loom from just the engine though, im trying to do a rb30/25det conversion to a VL calais and need a loom to hook up the new head through. Thanks Lars

hey all thanks for your time and help i didnt know i could search a thread. Thanks again lars

Hey all im new to the site. I have a rebuilt rb30 bottom end with forgies and an rb25 head with VVT. Can someone tell me what i have to do to adapt these 2 also what head gasket to use and if someone has a photo of where to put in the extra cam belt tensioner. Thanks.........i did see there is another thread about something similar but i dont have time to go throught 2500 replys to find what i nead. or if someone could link me to it. Lars