JDSracing

More seriously now, I'm thinking about selling the 180. The car is 1997 Type X Approx 120,000km's Sun Roof, Air Con etc Rego until December The car is modified, rather extensively, all modifications to the car have been performed since I purchased it in December 08. It is currently running 1:10s at Wakefield on low boost (approx 180rwkw) and street tyres. It makes 209rwkw on high boost, all the way from 3000rpm to red line. This car is not for the faint hearted, and would suit someone who is chasing circuit times, or looking for a fully prepared drift car. - HSD HR Coilovers, - Adjustable castor rods, - Whiteline sway bars, - Genuine Nissan front strut brace - Carbon Fibre Rear strut brace - 4 to 5 stud conversion with R33 GTST brakes - Bride Brix 2 drivers seat - Momo Gearknob - Momo Steering wheel - WorkBell Rapfix quick release - Nardi Z32 Boss kit - Aftermarket Pioneer headunit - HDI Boost Gauge - Sparco 3 racing harness - Fibreglass Du Luck vented bonnet - Aerocatch bonnet pins - RPS13 carbon fibre rear centre garnish - HDI Dual Stage Boost Controller - Nistune ECU - K&N Pod filter - Blitz BOV - HDI front mount intercooler - Xforce catback exhaust - T518Z turbo - Walbro 500hp fuel pump - Xforce Dump pipe - Apexi Turbo / Exhaust Manifold - Greddy Oil filter sandwich plate with Thermostat - Tomei Poncams - Nismo 740cc injectors - Nismo Thermostat - Bosch Z32 Air flow meter - Oversized Water pump pulley - Oil cooler kit - Alloy Radiator - White Work Emotion XD9's, with Work Wheel nuts etc I'm sure there is a fair bit more as well. Most stock parts included as well, along with a bunch of other random spares. Asking $18,000 as is, but would be happy to negotiate the cost down lower with less parts on it. The car will be de-stickered soon and then I will update the pics. If your interested, send me a PM and we'll go from there. I'm looking at getting a evo 7 / 8 after this, so if you have a relatively stock one I may be open to trades.

If you just want the track time (without the EPCC stuff), it is $295 to book it through Circuit Club. I'm thinking about it, I've never had a proper run on EC.

Heaps of gear for sale, Lightweight BBS Rims, 4 x 114.3, all in good condition with BBS center caps and BBS valve covers. One rim has small gutter rash. Fronts are 17 x 7 Rears are 17 x 8 Tyres fitted at the moment are 2 x Falken Azenzis on the front (worn), and 2 other not so good tyres (really worn) Asking $1200 ono FD3S RX7: - FD3S RX7 RS-R Standard springs and shocks (all four corners) - $200 S13 Silvia Parts / 180SX Type X parts: - S13 Silvia Taillights x 2 - $50 - S13 Standard Side Mount Intercooler - $80 - S13 Front Sway Bar + Link rods - $60 - S13 Standard Tension Rods - $50 pair - S13 Super Hicas - working fine - $70 - S13 Standard Diff Centre - $90 - S13 Whiteline quick release front strut bar - $150 - RPS13 Leather Type X air bag steering wheel - $250 - RPS13 standard brakes, front & rear with Ferodo DS2500's - $150 - RPS13 front LCA's - $100 pair - RPS13 front hubs - $100 pair - RPS13 Standard Turbo + manifold - $150 - RPS13 Standard AFM - $150 - RPS13 Standard Injectors - $80 - RPS13 Standard Radiator - $100 - RPS13 Standard Cams - $100 - RPS13 Standard Thermostat - $50 - RPS13 Standard Waterpump pulley - $30 - RPS13 Standard Waterpump - $50 R33 GTR Vspec parts for sale: - std front GTR sway bar - $50 no link rods - std computer - $150 - std centre guage cluster - $100 - std springs and shock assembly (all four corners) - $200 shocks have been rebuilt, very good condition - aftermarket front pipe for twin turbo setup - $80 Small Damaged Area on Front pipe: Parts are located in Sydney, pickup only! PM me for contact details!

Type X by any chance? If so, I need the ABS unit, drivers side and passenger side window switches. Can pickup while on the Gold Coast next week.

Ah, that would have been me! I thought your number plate looked familiar, but I wasn't sure. I was in a hurry to get back to work anyway.

Rear diffuser sold!

Misc: - FD3S RX7 RS-R Standard springs and shocks (all four corners) - $200 S13 Silvia Parts / 180SX Type X parts: - 6 alloy rims - $300 2 x Work 5 spokes 15x6.5, 4 x 114.3 4 x Mullins 5 spokes 15x6, 4 x 114.3 (2 spray painted black) Tyres are reasonable (some good, some below average), consider them drift rims. - S13 Silvia Taillights x 2 - $50 - S13 Standard Side Mount Intercooler - $80 - S13 Front Sway Bar + Link rods - $60 - S13 Standard Tension Rods - $50 pair - S13 Super Hicas - working fine - $70 - S13 Standard Diff Centre - $90 - RPS13 Leather Type X air bag steering wheel - $250 - S13 Whiteline quick release front strut bar - $150 - VARIS Carbon Fibre rear diffuser - $450 R33 GTR Vspec parts for sale: - std front GTR sway bar - $50 no link rods - std computer - $150 - std centre guage cluster - $100 - std springs and shock assembly (all four corners) - $200 shocks have been rebuilt, very good condition - aftermarket front pipe for twin turbo setup - $80 Price drops, moving in a few weeks, need this stuff gone! Note would trade parts (& cash where needed) for other parts of interest that I still need; - Rays Lugnuts, 25 x 1.25mm type - Takata 4 point, 3" harness - Bolt in cage for 180SX - R33 GTR Passenger seat - R33 GTR Brembo's (Callipers Only, no pads or rotors) Also, seeing if I can pre-sell these rims, they will be off the car and available in approximately 3 - 4 weeks at this stage. Lightweight BBS Rims, 4 x 114.3, all in good condition with BBS center caps and BBS valve covers. One rim has small gutter rash. Fronts are 17 x 7 Rears are 17 x 8 (offsets coming later tonight) Tyres fitted at the moment are Falken Azenzis (615s), approximately 3 weeks old, 90% tread remaining. (One tyre has tiny flatspot - slight noisy up to about 55km/h, only going to be noticeable if you run lots of camber). Asking $2000 Parts are located in Sydney, pickup only! PM me for contact details!

I'm looking for a set of either R33 GTST brakes or R33 GTR Brembo's / Z33 Brembo's. I need all 4 Calipers, I don't need pads, but I may need rotors. They must be from an ABS equipped car. Does anyone have any or know of any for sale? I'm also after the following parts, so if you have these too, I'm your new best friend: R33 GTS-T rear hubs Z32 Hand Brake Cables S14 Lower Control Arms Able to be picked up in Sydney much preferred. Thanks.

Bringing this back up, Note would trade parts (& cash where needed) for other parts of interest that I need; - R33 GTST brakes + S13 5 stud conversion gear (either aftermaket hubs or S14 gear) May also consider S15 / Z32 front Callipers - Set of Work Emotion XD9's (Gunmetal preferred) in 2 rims x 17 X 8.5, 5-114.3 / +25 2 rims x 17 X 9.5, 5-114.3 / +17, or +28 - Rays Lugnuts, 25 x 1.25mm type - Takata 4 point, 3" harness - SR20, 740cc Injectors - SR20, Nistune or PowerFC ecu's - Z32 afm - Oil Cooler setup for SR - Aftermarket radiator for SR (42mm or larger)

This definitely sounds interesting, I think I will give it a go depending on how strict the regulations are and how much work I will have to do to the car to make it comply.

SAU Nickname: JDSracing Car Make and Model: 1997 Nissan 180SX Circuit Name: Wakefield Park Lap time: 1.12.4 Engine: SR20DET Power: About standard, FMIC, catback exhaust, Boost at 10PSI Suspension: coil-overs, sway bars, & tension rods Tyres: RT615's Brakes: stock rotors and calipers, Ferodo DS2500 pads, braided lines Body weight: 1200kg First track outing in the 180, and I equaled the best time I got out of the GTS-T years ago! Pretty happy with it so far.

And it has also made you forget that it was a 1995 model.. It's good to hear your still racing over there!

"This was booked many moons ago when Monday 27 April 2009 was still a public holiday... The good news is, now that it isn't, its a lot cheaper at $145! (Includes official timing) For those in ACT it is still a public holiday... But for the New South Wales dwellers - start getting your leave applications in now! Hope to see you there... " For bookings, email [email protected]

Alright, garage cleanout time, this is what is still for sale. Misc: - FD3S RX7 RS - R Standard springs and shocks (all four corners) - $300 S13 Silvia Parts / 180SX Type X parts: - 6 alloy rims - $400 2 x Work 5 spokes 15x6.5, 4 x 114.3 4 x Mullins 5 spokes 15x6, 4 x 114.3 Tyres are reasonable, consider them drift rims. - Silvia Taillights x 2 - $50 - Standard Side Mount Intercooler - $80 - Front Sway Bar + Link rods - $60 - Standard Tension Rods - $50 pair - Super Hicas - working fine - $70 - Type X bonnet, silver, as new - $250 - Standard Diff Centre - $90 - Leather Type X air bag steering wheel - $250 - Whiteline quick release front strut bar - $150 - VARIS Carbon Fibre rear diffuser - $500 (pictures below, the actual diffuser fitted to a friends old car) R33 GTR Vspec parts for sale: - std front GTR sway bar - $50 no link rods - std computer - $200 - std centre guage cluster - $120 - std springs and shock assembly (all four corners) - $250 shocks have been rebuilt, very good condition - aftermarket front pipe for twin turbo setup - $150 Small Damaged Area on Front pipe: Parts are located in Sydney, pickup only! PM me for contact details!

Also for sale: - VARIS Carbon Fibre rear diffuser - $600 (pictures below, the actual diffuser fitted to a friends old car)

Revised for sale list as this thread is getting really hard to follow: Misc: - FD3S RX7 RS-R Standard springs and shocks (all four corners) - $300 S13 Silvia Parts / 180SX Type X parts: - 10 alloy rims - $400ono 2 x Watanabe(?) 5 spokes 15x6.5, 4 x 114.3 4 x Auscar rims 15x6.5, 4 x 114.3 4 x Mullins 5 spokes 15x6, 4 x 114.3 Tyres are reasonable, a few rims even have new tyres to make up for the pair on the belts. - Silvia Taillights x 2 - $50 - Standard Side Mount Intercooler - $80 - Front Sway Bar + Link rods - $60 - Standard Tension Rods - $50 pair - Super Hicas - working fine - $70 - Type X bonnet, silver, as new - $250 - Standard Diff Centre - $90 - Leather Type X air bag steering wheel - $250 - Whiteline quick release front strut bar - $150 R33 GTR Vspec parts for sale: - std front GTR sway bar - $50 no link rods - std computer - $200 - std centre guage cluster - $120 - std springs and shock assembly (all four corners) - $250 shocks have been rebuilt, very good condition - aftermarket front pipe for twin turbo setup - $150 Small Damaged Area on Front pipe: Parts are located in Sydney, pickup only! PM me for contact details!

Brand unknown, pictures in 2nd post. Also, Type X rear seat gone, Nismo shocks + king springs for S13 gone, S13 rear sway bar gone,

Dump pipes are gone! Front pipe still available - $150

Ark, they are in good condition, I don't believe they had been fitted to the car for long before I removed them. Resulting ride height is roughly an inch lower than standard.

Also for sale now: 180SX Type X Parts: Standard Swaybars + Link rods - $100 pair Standard Tension Rods - $50 pair Nismo Shocks + King Spring Combo (all four corners) - $250 Super Hicas - working fine - $70

I am entered, to make up for selling the last car 5 days before the event last year. This is going to be awesome.

Thankyou

PM Sent!

PM's replied

Rear sway bar sold, front still available - $50.