luke20t

Ive moved out of home and dont have much access to the net atm.. RIP to the guy, not nice hearing about things like this.

Did u find out what the problem was? im having the same probem with mine atm. really pissing me off. It started of sending torque to the front wheels under meduim acceleration. now it has just got worse over time that it will start sending torque to the front wheels even with 1psi of boost at any point in the rev range. Taking coners is a bitch now- getting heaps of understeer. My tyres are the same diameter. i have tried different wheels and tyres also.

^ as above. i really doubt they would be that picky. wheels should be fine aslong as they dont sit out the guards. might even get away without that brake light.

but thats all sr20 gear?

cheers both of u ill look into it this week sometime

no one else?

im sure one will be made, will let ya know.

My RB26 has a problem blowing T4 gaskets and the manifold needs facing. Sooo i need to remove the turbo and manifold (single turbo setup) then send it off to get machined. Where do i get a new manifold gasket and T4 gasket from? i know nissan would have the manifold gasket but are there any other options? Anything else i need to know? thanks, Luke.

nice car, plenty of room inside? been to vq30det.com? -its perth based too

+1 with NOT going the rb20 route.. u will regret it in the long run.

my opinion a safc is a waste of money if your gonna be doing more 'serious' mods in the future.

got good duck ey? ducks my favourite

keep it looking like a stock item like the rest of the cars components and they shouldnt notice it. but really depends on the inspector u get.

if it doesnt sit much higher than your steering wheel and doesnt block any vision it should be fine.

dont forget all the shit that went down with the DPI and 5 inspectors fired. things will be much harder now..