who's next

I am getting a good deal on a set of r33 front breaks, could anyone tell me if this would work on the a31 cefiro thanks

If u are located in trinidad let me know and i would tke the 6 of them off ur hands, if not it would cost me 2 much to ship them down

i have a rb20e engine in my cefiro it is working good for now, i was changing the o-ring on the injectors (as it was leaking) and in the process one of the injectors fell and cracked. Now it is proving real difficult to get one to replace it. what i want to know is: 1) Would the rb20de injectors work on the rb20e engine, they look like the same but would i run into problems with the air/fuel mixture as i assume that the rb20de incector would be more cc than the rb20e injector or is the difference small and would not make much of a difference. 2) my engine is stock however i plan to put in a performance coil. plug wires and some good plugs, pod filter and 3inch exhaust. so would the higher flowing injector be applicable to the following mods or would the stock one work just as good dont worry this is just for the short term untill i put in a rb25det Thanks

I would also like to know if the rb25det gear box would bolt up to the rb20e engine

i bought a titanium muffler (it looked like a stainless steel one) but when i went to the muffler shop to put it on the wleds were just breaking off, he (the muffler guy) said its because the material that the muffler is made from was titanium. The muffler guy did not have the correct equiment to weld it on to the pipe. my question what type of welding rods shoube used to weld the muffler on to regular pipe, and would tig welding work?

ok, next time i would try it ur way

both ways are correct the 1st way is to remove the outer steering ends and the second for the ball joints (two different parts) the only thing i would different is after u put the nut back on so that the treads dont get damage is to put a small 2x4 piece of wood on top the nut for a little added protection and then hit it with the hammer.

thanks, for the help

hey i just bought my ceffy, it have 2 switches by the foot breaks release one has power/auto/hold and the other has something like like a line with semi circle. what are these switches for?

thanks for the help i hope to start this project by may 2006 so right now i am doing all the research thanks again

Good day, i am new to this forum but not to the nissan family. i have a nissan cefiro stock with a rb20 engine (sohc) and i want to put in a rb25det. i would like to know if any of u guys have done this swap and could u share ur experience. i would be doing most of the work myself (with the exception of the wiring). any help that u can provide would be good e.g is it a straight bolt in or what mounts should i use, is the wiring easy etc. thanks