Jump to content
SAU Community

conan7772

Members
  • Posts

    856
  • Joined

  • Last visited

  • Feedback

    100%

Everything posted by conan7772

  1. You can also have the lenses and backs too. All lights work. so you can swap them in while you crack yours open and restore .
  2. Headlight restoration Can anyone recommend the best sealant to use to re- seal headlight lenses to backs ? The factory sealant is hard grey butyl that softens with heat. Some guys have used butyl sealnt from a tube. Just checking if it's compatible as there's heaps left in the frame. Got a pair of inserts for sale here $50 (Classifieds thread not working ) You can paint them and have them ready for when you pull out your headlights. Then swap inserts all in one day .
  3. Tried fitting it two ways, over and under the brace. Over is better, sits a bit low under. Great front end stiffening. Use a reamer to increase holes from 10mm to 12mm. Plenty of these braces available all the time I
  4. Fujitsubo legalis R Rear Muffler Rear Muffler only 3" Off M35 Stagea Pick up Avalon 2107 $200 See Gumtree ad
  5. Hey people, The R33 GTS-T / GTR rear strut brace is a perfect item to fit M35 Stagea front chassis. Remove the end brackets and throw out. Remove both centre back nuts and throw out. The tubes and centre bolt are a tad long so I cut 10mm off one tube section and 10mm off one end of the centre bolt. 775 centre to centre is the magic number. I used 50mm x 12mm hex bolts to connect to the under carriage. Spares holes illustred by screw driver. No need to unbolt anything You'll need to drill out the holes in the braces to 12mm, existing is 10mm Done for $50 in 20 mins and strong as buggery.
  6. Have you had a good look at the IPDM ?, could have moisture damage
  7. Still struggling with cabin noise, especially with my Mum in the car, so considering a large Varex oval muffler on the legalis r system. Does dump style tips make it any quieter ?
  8. Denso 570cc fuel Injectors 16600-JF00A New set of 6 Denso 570cc Part number 16600-JF00A Fits R34 GT-T R35 GT-R WGNC34 Stagea NM35 Stagea 350Z 370Z Skyline 350 GT Skyline 370 GT Postage $7 $280 ONO
  9. Headlights look black inside in that last pic. Did you do them ?
  10. Gee for a bit of bass, I'd be sweating all the time of getting a flat... At least you could listen to awesome sound while you're waiting for the tow truck. Run flats ?
  11. I think I can see some rust. Better pull out the engine Josh and rub it back to bare metal
  12. bloody hell, you've been busy
  13. I got them from the USA from an ebay seller 4Vpower. http://www.ebay.com.au/itm/09-17-Nissan-GTR-oem-Denso-stock-fuel-injectors-R35-3-8TT-VR38-great-for-370Z-/291952301234?hash=item43f9b694b2:g:eeEAAOSwFe5XxLXn
  14. Replaced Greddy IGN chip with another one and hey it works, no CEL. Had Jez replace my rocker gaskets, and while it was apart replaced my injectors. I had 570cc "Denso Australia" reman injectors, and had terrible starts and poor fuel consumption. 360km to a tank./ 6km per litre. These also had leak down. Bought used R35 injectors and what a difference ! Car starts perfectly, economy way way better, 9km per litre, and my exhaust is 10db quieter. I've been mucking around with silencers trying to get it under 100db with minimal restriction. These shit injectors, give such bad atomization, hence why I was high risk of DET, causing loud exhaust tone. Also don't have rough idle anymore, and that rasp in the rev range is almost gone completely. Thanks Matt for the info.
  15. Is she running yet ? , I see you got rego plates on it. was it hard getting blue slip
  16. I managed a pretty good 4 wheel spin in the wet , launching.. But dry road ,,, don't forget she's almost 1700 kg
  17. Electrical Fault So I have a miss. Cold starts, it idles rough on 5, then corrects itself when warm. If I accelerate however when this is happening, it'll be fine, only on idle / low current. Then occasionally on long hot drives, I'll get very brief cutting out. Does this sound like the ignitor or leads? cheers
  18. R35 OEM Injector dead times Hi , Could someone post up the latency values for the stock GTR injectors please. Denso 570s Would be great to have 8v 10v 12v 14v 16v thanks
  19. butyl tape or out of a tube ?
  20. Picked up a pair of spare lights to restore . Gonna oven bake them at 100C for 7 mins to break them open. Then spray the insides in a large flake heavy metallic black. What is the OEM sealant and what's the best way to reseal ? Tube silicone, butyl or butyl tape ? cheers
×
×
  • Create New...