ReQuieM

Are these road legal?

Selling a 3" exhaust control valve, Not an autobahn special, I ordered it in from the US. has a motor on it driven by a switch you can mount in the cabin. variable close based on how long you hold the switch down for. 2 wires, power and ground. 2 bolt 'flange' about 1.5" thick. comes with a gasket and two flanges so you can cut and install it if you'd like. I just mounted it after the cat. Used for about two days but I'm pulling the car off road to do some more work on and I could do with the money instead. Chasing $250 +p&p or pick up in melb. for those that don't know this is used to give you in cabin variable noise reduction better pics on the weekend

Sorry melbourne BUT I'll pm you a special deal How cool is this fka:

Oh and just in case some one looking is worried, they were quite dusty when I photographed them. They aren't spotty, just very sex!

Time to go. I've just got my sexy new rims, so why not buy my old sexy rims and you too can have sexy new rims... like me.

Would you sell this part seperately? Its the piece that connects the ITB linkage arms to the throttle cable.

Hey, My new rims will on there way to australia shortly so its time for these to go. All serious and resonable offers considered! 17x8 + 45, 17 x 9 (similar offset, rear sticker is missing tho). 5x114.3 and 4x114.3 Suit most jap cars. Small dish at the rear. Near new rubber, still have the little hangy bits they're that new. Rims are in near perfect nic just need a clean as the car has bee sitting for a while. The rubber is about a 1g on its own. $1200 ono I'm in melbourne. PM or ask here.

Bump

One last thing, do you have anothor shot of the dyno graph with the RPM viewable? I'd like to see the lag on its previous set up. Cheers

What trim was it? 40, 46, 50, 54, 57, 60? I Noticed the compressor cover has an AR .50 stamped on it, possibly a 50 trim to start with? By 'Hi-Flow' what do you mean? Debured and smothed? or has it been ported? How heavily? and has this porting been done on a flow bench or 'by feel?' Also can you supply some of the following trim sizes: Compressor inlet pipe compressor outlet pipe Compressor inducer Compressor exducer Turbine wheel outlet Turbine inducer Turbine exducer I have a very keen associate, although we need to confirm that this turbo will suit the intended application. Cheers

Hey guy's Looking at sourcing a calper rebuild kit for a set fo R32 4pot fronts. They arn't going on a skyline so I don't have a VIN number which is making my life a little harder then it needs to be! Where do you just buy your kits from? is there a trader that can supply me one without supplying a VIN number? Any help would be golden. Cheers!

Go the MA70!

Updated first post. Gotta go, new rims on the way...

BTW DAN_J your inbox is full! I'll try and re-send my PM tomorrow.

I'm located in Melbourne. East bentleigh to be exact! Send me a PM if interested tho I'd preffer a local swap, just for ease. If you do contact me about a swap could you please first check that you have the m-spec 4 pots. There are two ways to tell. 1 your stock set up ran a 280 x 30mm disc. 2 is to measure the space or groove in the caliper that allows the disc into the caliper on each side of the pads, it should be 35mm wide. Oh and they should be aluminium! Cheers! The groove: http://www.princeton.edu/~asad/zbrakes/pages/9.htm