Thought I would write this up as I was struggling quite a bit with this one, and now have it down to a fine art.
Tools required: 1 x stubby phillips head, 1 x long thin phillips head.
OK so the story is I wanted to install some LED bulbs for the cluster and "piggy back" off the Oil Preasure guage wiring for a better gauge.
So here are the steps:
1. Unscrew the 6 screws under the steering column and drop it as low as it can go. Then pop of the top cover behind the steering wheel (see pic)
2. Unscrew the 2 screws at the top of the cluster surround
3. Pull the cluster surround out by pulling first a the top and then the bottom.
4. Disconnect the Climate Control Sensor wiring clip and tube (REMEMBER TO PLUG THESE IN WHEN YOU PUT IT ALL BACK TOGETHER! OTHERWISE YOUR AC WILL BE EITHER HOT AS OR 18 DEGREES ONLY!)
5. Unscrew all the 3 screws holding the cluster in.
6. Disconnect the 3 wirring harnesses from behind the cluster. The one on the left is a particular bastard as the clip is located behind the accesable side of the plug. Not really much I can say here other than it is a real pain to get out. Once it is out I suggest destroying the clips on these so they can easily be removed in the future!
7. Finally pull the cluster out. The only way you can get it past the steering wheel is to the left as shown below.
Once the globes are changed, reverse the process to reinsert. I can now complete this process in about 10 minutes.