12VES

WTB R32 Sunroof Hey Guys, I'm chasing a sunroof assembly for an R32 Gtst. Must be complete and in working condition. Cheers Dylan.

pm sent...

Exhaust sold Airbox, crossover pipe, intake pipe and steering shroud sold T04E turbo setup sold Hi-cas lockbar sold

PM Sent...

FC-Commander 415-N001

Hey Guys, I've got the following 32 parts for sale Factory ECU $50 Power FC Hand Controller Suit AP Engineering Power FC (Not Sure What Other Models It Suits) $150 Factory Rear Spoiler Good Condition (Blue) $100 RH Tail Light Good Condition Has Small Crack In Indicator Lense (Black) $50 LH Front Headlight Good Condition $50 Factory Airbox With HKS Panel Filter $50 Factory Turbo Good Condition $150 Factory Dump Pipe $20 XS Power High Mount T04E Turbo Setup With Manifold, Dump And Front Pipes And 38mm Wastegate With Screamer pipe. Turbo Suit Rebuild $200 SOLD Trust 3 Inch Cat-Back Exhaust Good Condition (Has A Few Small Holes And A Few Scrapes) $150 HKB Hi-cas Boss Kit Suits Nardi And Momo Steering Wheels $50 Steering Column Shroud Good Condition $20 Hi-cas Lock Bar Good Condition $50 SOLD Factory Intake Pipe $10 Factory Crossover Pipe With Factory BOV $20 Malpassi Fuel Pressure Regulator $25 All Parts Are Located In Kenmore, Brisbane Pickup Only Call Dylan 0418793749

PM sent...

Anybody???

Cheers guys I'll have a look into it...

If you change the seal on the rear wiper, be careful because it's quite common to strip the thread on the wiper motor when removing the nut. Nissan want about $800 for a new rear wiper motor...

PM sent

Price Drop $100 for the 450x300x76mm and $150 for the 600x300x76. I need these gone

I've got a Walbro intake pump, and I'd recommend one. I think mine was fitted for just over $200.

Coolant lines to turbos???

Check your boot seal and also around the spoiler, these are two common places for leaks...

Hey everyone, I have a 3inch Jasma cat-back exhaust off an R32 Gtst for sale. It is in good condition but has a few scratch marks on the bottom and a few rust holes, but otherwise is fine. I'm looking for $250ono I'm in Brisbane call Dylan 0418 793 749

Here's some pic's 450x300x76mm 600x300x76mm

Hey all, I have a couple of Hybrid copy bar and plate intercoolers for sale. They are 450x300x76 and 600x300x76. Both are brand new still in boxes and never been fitted. I'm looking for $150 for the 450x300x76 and $200 for the 600x300x76. I'm in Brisbane and would prefer pickup Call Dylan on 0418 793 749

All the things above plus a full engine reseal...

I had a similar problem on my 32 that occured around the 2200 mark. I found that it was one of the heat-shield welds on my metal-cat cat converter had broken and was causing it to vibrate. However if you are suss on the car don't buy it. There are plenty of others for sale.

I agree. It sounds like you have a coilpack arching out when the engine warms up. I'd go for splitfire coilpacks, I put a set in my 32 and I'm more than happy with them, they're well worth the money.

That anti-squeal paste is good stuff and works a treat if you have shims or backing plates on your brake pads. A few other things to consider are that alot of brake pads have an audible warning built in to let you know when the pads are getting low. This usually consists of a piece of metal that rubs on the disc rotor when the pads are low. This can sometimes be bent during installation and cause it to prematurely rub on the rotor causing an audible sqeal. Another thing to consider is the high copper/metal content in the pad which will also cause squealing.

Agreed it looks like corrosion. Check the coil cover seal and see if it's damaged at all. Someone at some point may have washed the engine bay, and water probably leaked down and sat around the plug.

Just get a genuine one from Nissan. It might cost a bit more but it will save alot of hassle in the long run....

Yeah I'll give that a try and see if it makes a difference. I just don't understand why it was fine for so long and now it has started happening again.