RB25HR31

here's the story for the HR31 - i'd assume it same for the 32. you need: - R32 GTR Pinion Assembly (32707) - R32 GTR Cog (32703) - Pin to hold Cog in the assembly (32712) - Washer thing to hold the assembly to the box (32718) all up cost me $140 even for everything, but my speedo is SPOT on. you take out the old one, put the cog throught the housing and hammer in the pin in the side so the cog doesn't fall out, oil up the housing and the gearbox case where it slides in, using a rubber hammer, bash it in till the groove sits flush with the box, (there is also a mark at the top of the pinion housing, have this point dead vertical) put the washer thing in (you'll know what i mean), tighten it all up so it doesn't go anywhere, slap on your speedo cable, and take for a test drive. Chris. edit - well scrap that idea. got 160kms out of it and the gear wore away - teeth are cut the wrong way. didn't pay too much attention just slapped it in and bang.

BUMP! OFFERS! thanks. chris.

i have HR-31 with a 34 GTT box in it. so i think same story with r32s. i bought the R32 GTR pinion assambly and cog. found out today i also need some clips and other bits, as i was really interested to know how the assembly is not meant to fall out of the box, and how the cog is not meant to fall in. the assembly and cog from nissan is $130, and the other bits and pieces to hold it all together is another $10, which i have to wait on. will post up in couple days how it goes.

SOLD. please remove.

sold to me.

guys i got a turbosmart bov on my rb25 that looks like it had a huge trumpet comin out the side. i need a fitting that will screw into the hole it vents out of (around 3/4 inch but not that size - i've tried a few 3/4 and couldn't screw them in) and on the other end of the fitting a brass (or whatever) hose end that will allow me to fit the stock 25mm hose on and allow the bov to vent into the intake. PM me your number if you have what im after and i will most definately give you a ring. cheers. chris.

SOLD. please remove.

http://www.skylinesaustralia.com/forums/in...c=21079&hl= ok. well i've answered my own question then. the circlip things are there to hold the stock shifters in place. it's the cover that goes along the top of the short sihter and has the clamps along the side which holds the short shift setup in place. i just coudn't work out if there was anything else there to hold it in place.

cheers for reply but the link doesn't work for me? it says NISMO on the side - who knows then...?

hey guys im new here and need some help fitting my short shifter. i just purchased a car with a R34 box and a nismo short shift kit which likes to pop out sometimes and is very annoying to fit up along the side of the road. as i never originally fitted it im not to sure how it's meant to go in. below are some pics of what i've got - dont know what the o-ring things are for - however there is a ring in the selector column where i could 'make it fit'. the way it was - the fat spacer thing went in first, then the shifter popped in, then the cover went on and with the 4 bolts fit intot the grove along the side. cheers. chris.