08r3308

as per topic guys im wondering if r34 snorkel will fit a r 33? would there be any benefit of doing so?

had them in my car inside door panel for over a year and they been fine , no water will get it for sure most wont need adjusting for basic user , unless you are sq freak then in that case diff story.

as per topic i have alpine 9887 deck for sale , best sound quality , so many adjustments , top of range deck in mint condition and with 12 mnts warranty more info on deck here http://www.alpine.com.au/products/product.asp?modelID=365 im located in Sydney and can post anywhere $450 firm

would the snorkel fit r33 airbox by any chance?

what he said , they fit perfect and no water gets in that's where i have mine mounted

suits rb25det so r33 , not sure about rb20det

1. polished cross over pipe $50 great condition bling bling 2.black 2.25"-3" silicone reducer perfect for new intake pipe $25 brand new 3.apexi pod with apexi bracket $60 like new , seen few weeks use 4. wild weekends 09 cd brought today $20 i can send interstate but buyer pays postage , shouldnt be more than $10 for any item firm on prices as its cheap already any questions pm

as per topic i need a single R33 GTR stock plumb back bov

if installed properly there will be zero noise even with $10 cables .

is PA11-NIS all you need? where did you order yours from?

i cant believe you didn't sell this , its great upgrade and cheap too. will make so much more power and make car run smooth best luck with sale

hey guys im after a r33 plumb back/breather piping that connects to stock intake pipe also stock gear knob in good nick

when i had same thing happen in my old tx5 there was no coolant too but it was heater core , would be wise to check it out.

im afraid heater core check under dash and see if it gets worse once heating is on

i couldn't hear much difference between $30 cables and $250 audision ones. i guess it all comes down to how much money one has to spend

1. you run the sub off the amp same like any speakers it requires a wire from amp to sub 2.take for example; a 2 channel amp puts out 100 x 2 rms. each channel is receiving 100 rms respectively. by bridging the amp, you are combining channels to put out 200 rms to only 1 channel 3.always keep rca separate to power wires. i usually run rca and speaker cable down passenger side and power on drivers side in r33 its very easy as you have battery in boot so only requires a small amount of power wire as for noise i had issue with noise being induced thru power wire for head unit , but you might be lucky . i sent you pm hope this helps

anyone notice the rear trims unglued once he used water to clean it

would you cod?

you need amp turn on cable, run rca to amp and that's from units side, then you got power and negative on amp , plus connect turn on wire and rca to amp and bridge speakers for sub and your done should take to 30-45mins and dont take it to your jb hi fi or strathfield to wire it trust me

chek your pm mate there is cheap doof doof quality too

need this stuff gone

you have pm

as per topic guys prefer one in Sydney if possible

rocker cover gasket. its not that hard to replace and should cost under $80 for a Nissan part

does anyone have a picture which way they are supposed to be in a r33 with speakers on parcel shelf i have searched but could not find anything