Jump to content
SAU Community

EPGUN

Members
  • Posts

    7
  • Joined

  • Last visited

  • Feedback

    0%

Everything posted by EPGUN

  1. but why would it only do it at 50mph as it does not do it any other time
  2. hi i found out why i am having problems see if anyone can help me in anyway . if the car slows down to 50mph i get check engine light come on for 1 second then go off this uts a airflowmeter tfault and causes tcs to stay on, what i have noticed is that wen car gets to 50mph for a split secont the output afm signal go to 0v wich causes the problem any ideas
  3. has enyone used a z32 maf on auto box model r34 gtt as i am having issues with it z32 maf is wired correctly setting change on e manage . but when it get to 3500-4000 rpm it just holds backs . but when use stock maff its ok , it feels like car does not know when to change gear etc
  4. hi all i am back on land of the skyline but now with r34 gtt auto i recently put on the following e manage ultimate with ignition adaptor and set to 12v with complete universal loom specs are nismo fuel pump blitz 540cc injectors lag set to 1.02 and .60 for stock and new roller bearing turbo unit with steel turbine the problem i am having sometimes you can struggle to start 1 .when it start it idles fine etc but it has slight misfire once evry few seconds but revs very clean 2 . one you drive it after few minutes tcs and slip light will come on and stay on and canot switch it back on and sometimes it will stall also how do i remove fuel cut any help would be greatly apreciated thanks
  5. thank for the rply i was following ch1 for ign1 ch2 for ign 2 etc etc thats how it came up with fault all ok now just had to swap a few wire around aprt that i had ran it on 5 vaults can can the damage be
  6. ok i sorted that error out but what voltage do i run 12 or 5
  7. hi there i wonder if anyone can tell me where i am going wrong gor r33 gtst 1995 i have wirried emu but i keep getting these error shortly after car is running 30:0441-0005[incorrect 1CH ignition input signal] 31:0442-0004[incorrect 2CH ignition input signal] 32:0443-0006[incorrect 3CH ignition input signal] 33:0444-0001[incorrect 4CH ignition input signal] 34:0445-0003[incorrect 5CH ignition input signal] 35:0446-0002[incorrect 6CH ignition input signal] ii have checked wirring and is ok i have swaped jumpers over but still get the same fault do i ahve to set jumper to 12v or 5 volt for this car would greatly apreciate it
×
×
  • Create New...