Hi Everyone,
Been a while since i started my biuld, but shes finally comming on.
Quick question i have for you guys, been searching the net for a few days, and cant find any specific answer.
I am finishing my dry sump build, and was planing on fitting a npt male to -12an male fitting on the oil inlet on the block (thread where oil filter bolts on). but jut realised there is a oil spring release ball bearing in the block itself, is this for pressure release or draing back? can i just ignore this and go ahead and fit a fitting straight into the block, or would i have to take this bearing out and tap it and fit a grub screw?
thanks again
simon