sherlock_nzl

check power supply/earth at rear window before u do anything to ensure that is the problem.

Cant remember how lock is held in place on skyline but on other nissans I have put hacksaw cut through end of broken off bolt to make screwdriver slot and undo with screwdriver, or maybe remove steering wheel and put hacksaw through lock and break it off.

Pan Pacific Auto Electrical, Try Auto Electrical shops, Auto radio shops for car radio bulbs, I got an original good bulb and measured the resistance and then checked the new bulbs to get the same or something close as I didnt know what wattage they were. Auto electrical shops have universal dash bulbs that just need a bit trimming off them.

U can buy bulbs in holders and with removing a small amount off the lugs they will fit. or u can buy bulbs with 2 wires about 25mm long out of them and fit them to your old bulb holders. very carefully with the piont of a needle, run it around the bulb to remove the blue condom and fit it to the new bulb other wise the light will come out yellow not white.

If you have scrubbed out a set of tyres in 4000km on the inside of the tyres I would say you have to much toe out on the rear wheels. Get a wheel alignment done. Camber dosen't scrubb out tyres and you dont have caster on the rear

Daigram of fuel pump and relay, hasnt got colours but should be easy enough to work out whats wrong from it. Cheers

Auto shops, Dick Smith you can get a set of 4 actuators

R33 service manual I downloaded works a treat from the UK

I dont know if I am just reading you wrong but you say you keep your turbo timer on for 1-2min after the first start up,................the turbo timer is for your turbo to cool down after a hard run......................After you turn the key off your engine will run for another 2 min....................Very sorry if I have missunderstood you Cheers

Ya can get pirate pumps but dont know if they fit Skylines, might be worth checking out. Check Fuses and power supply first. Cheers

Hi Most likely thrust bearing noise. There is a spigot bearing in the flywheel but I dont know what sort it is but it could also be that. I usually put a very small amount of nickel antisieze on the clutch spline to ensure that the plate slides freely on spline, but even dry it will not make a noise. Cheers

An R32 key wiring diagram if any help

Get power tester (light bulb) and check at the key plug connection and u will soon find which is which

Well the one that I replaced was a resistor because I could see a couple of coloured rings but couldnt tell what colour the other rings were, In mine only one section of the LED's had gone out, about a dozen. they must use both diodes and resistors on the different models Would I be right in saying to identify which you have, diodes are usually black with a silver ring around them with the diode symbol, and the resistor is usually cream coloured with coloured rings around them to show resistance value Cheers

Hi Skyline33 Yes I can do that You must have a working copy of Fast I guess, If you want to know how to use it. mine doesnt work if I could have a copy please. What size email can you take What year are your files. mine are mostly 1999 What operating system are you using Cheers