Jump to content
SAU Community

32TAXI

Members
  • Posts

    773
  • Joined

  • Last visited

  • Feedback

    100%

Everything posted by 32TAXI

  1. Either the missus or pipster outside aussie fair, what time was it? Been seeing pipster everywhere lately!
  2. Mine started to heat up especially with A/C turned on or on dyno. Ebay alum. asi performance 52mm $199 delivered! Sits at 84-85'c with A/C on, boosting and Qld summer. ### p.s. guage didn't move from 1/2 even at 99'c!!! ###
  3. Pic's
  4. I work sunday's in southport opposite pool/park. Might pop out if i see ya's!
  5. R32 GTST BLITS VENTED BONNET ADR approved - In gel coat(white) - bit of TLC needed $550 or swap 4 GTR bonnet and guards Sam 0423 648 114
  6. R32 GTST BLITS Vented bonnet ADR approved - In gel coat (white) - bit of TLC needed $550 or swap 4 GTR bonnet and gaurds Sam 0423 648 114 Gold Coast
  7. No sorry - fitted std centre back in.
  8. OS GIKEN 1.5 WAY LSD SUIT R200 Inc. 2x 3x2 bolt halfshafts (modified to suit 3.9:1 auto housing) Removed and fitted standard centre. little use - quiet operation - locks great $600ono Sam 0423 648 114 Located Gold Coast
  9. OS GIKEN 1.5 WAY LSD SUIT R200 Centre and 2x half shafts only. 2x 3x2 bolt modified shafts to suit 3.9:1 auto housing. Removed and fitted standard centre. little use - locks great - quiet operation $600 ono Sam 0423 648 114 Located gold coast
  10. That was me! Went camping for a few nights, but it rained! Yours looks sweet - love that front bar!
  11. Got power to pump + No fuel pressure before filter = Replace pump (I had a walbro full of sand + Sock intack and not damaged = warranty)
  12. And cleaned properly!!! machining cast will bring carbon to surface and if not cleaned with solvent will cause slipping & shuddering.
  13. Ballast on S2 stagea, between headlight and hi beam - bolted to side of headlight. Will have to remove headlight to access - remove grill, then hi beam - front bar stays in place ###dont forget bolts from rear of rad support panel###
  14. My yellow S2 in mudgeeraba - Its not so shabby now! Just seen another yellow S2 Days with carbon options (rsv##) outside southport pool, anyone here?
  15. RS4S - Power FC - Blitz zorst - Greddy fmic - Hks pod - T piece boost control 150 awhp std ecu (surging and slurping) 173 awhp untuned pfc 194 awhp @ std boost - tuned PFC 206awhp @ 11psi - tuned PFC
  16. 130,000kms Goes good, but needs radiator!
  17. Weatherstrips - best to remove side glass first - use pick or small screwdriver to remove plastics clips from inside door. Outside Door moulds - glued on and locators(no clips) - pull hard Roof racks - bolted and doudle sided tape - remove headlining to access bolts - Be careful!! (cast alloy)
  18. Got pulled over twice in 2 days just a few weeks ago, first just a lazy sunday arvo RBT - no problems. Second was a late monday night, got followed for a few kms, then flashed, so RBT + full check under bonnet. Idiot kept asking 'how much boost does it run' and pointing at T-piece??? Replied 'I didn't know overboost was Illegal'!!! Couldn't defect so he wrote a $320 ticket for undue noise!!!
  19. Abs ecu will need signals from engine ecu - tacho & speed. Engine loom should have wires spliced already if abs was fitted in half cut. Simply match up wires to body loom. Abs relays (above abs pump) also play up esp if playing in that area. Also check LH front abs sensor is plugged in - sometimes wires run in engine loom.
  20. Spotted 2x white S2 this morning! Approx 10am and both around Nind st, Southport.
  21. I can see your point regarding push clutches being alot cheaper, but alot of work to save few bucks esp if box is ok. Complete GTR R32 box inc. fork and throw out should go straight into RS4S with only push slave cylinder needed and maybe modified flexi-line. Gtr do also run a booster on clutch so be aware!
  22. R32 GTR box should go straight in with only mod to slave cylinder (pull to push).
×
×
  • Create New...