Jump to content
SAU Community

MattsR33

Members
  • Posts

    53
  • Joined

  • Last visited

  • Feedback

    100%

Everything posted by MattsR33

  1. Up for sale is my Sard 800cc injectors, Be lucky to do 5k klms, only selling as i have upgraded my fuel system, and have a 11mm rail. These suit 10.5mm (standard size) $500. Located in Perth Contact Matt on 0404 690 899
  2. Hey Guys, For sale is my Apexi Power FC (AP Engineering) computer with hand controller. Good condition, worked perfectly up until i pulled the RB20 out. Located in Perth, $900 posted to your door. Matt. 0404 690 899 call or text.
  3. Would you split Turbos, oil / water lines and sell seperately? Interested depending on shaft play etc
  4. PM sent, Interested in clutch, dumps, and turbos.
  5. I also know you lad

  6. Hey mate, can you please get a pic of the Dash faschia (Dash trim piece that goes under speedo, around to air con controls etc) Any unwanted holes, cracks, peeling etc? Cheers Matt
  7. Willing to split the front seats up mate? Im only interested in the Drivers seat. Also, im in Perth, im guessing freight would be expensive? Cheers Matt
  8. Hey mate, willing to split the seats up? Am interested in only the Drivers side. Im in Perth too so unsure how much freight would be? Cheers, Matt
  9. Hey mate, Do you have the standard R33 GTR drivers seat? If you will split them, how much shipped to 6169 WA? Thanks mate!
  10. Hey mate, just need the centre box (Goes under CD player etc) How much were you looking for that plus postage to 6169 Perth?
  11. I think the rims look awesome on it mate!! Bloody good effort. Very clean GTR
  12. GTR would cost abit more to put a 30/26 depending how far you go, but its still using the same block / head setup you would need to build. I havent even bought / built the sump - front diff yet. It all adds up very quickly as people have said!
  13. Gday mate, im also heading down the same path as you, but ive got a GTR 30/26. I got my block made at Spool Imports who im fairly sure are located in QLD. As people have said, 8-9k for engine / head work no where near enough for the amount of power you want. Ive spent roughly about 15k and my head isnt bolted to block yet. It probablly can be done within 15k for block done, head ported, new valves, springs, cams etc etc.
  14. Interested too mate, how much without guage holder? Location also! Cheers
  15. Half way there i guess!! Forged + balanced RB30!
  16. Hey mate, Im after the S2 Injector wiring loom, have you got it? Cheers
  17. I was thinking about going T51R kai. As thats somewhere inbetween the T04Z and T51R SPL. Is there that much of a difference between the KAI and SPL model? Should make more than 600rwhp with T51R kai if T04Z should get me there? Cheers
  18. Cheers guys! Yeah, ive always loved the T51R spool noise! T04Z on full? boost by 4000rpm is pretty good. Im leaning towards the T51R, alot of people have said dont bother with the T04z, but then again, vice versa. As long as its on boost before 5000rpm ill be reasonably happy with the result! I Spose time will tell! Cheers!
×
×
  • Create New...