RxDrift

Genuine GT35R turbo now $1000ono delivered!!!

Pressure reg sold. Everything else available still.

For sale: Genuine Garrett GT3582R ball bearing turbo. 600-700hp Item Condition: Great. I am selling because I have decided to get a slightly smaller turbo. Price and price conditions: $1100 delivered Extra Info: T3 with 4-bolt 3inch turbine outlet, 4inch entry 2.5inch exit compressor. Polished 0.7 A/R compressor housing, 0.63 A/R turbine housing. CHRA serial number 706451-5015 Pictures: For sale: Braided lines for turbo Item Condition: Lines and fitting are new and un-used. Price and price conditions: $60 delivered Extra Info: -10 oil drain line with 45deg fitting. -6 oil feed line. Pictures: For sale: SARD Standard Type Fuel Pressure Regulator Item Condition: Came with a fuel rail and I don't need it. Price and price conditions: $80 delivered ($220 new from GCG) Extra Info: -6 fittings. 200-800kpa Pictures: Contact Details: Reply or PM or msg/Call 0416 143 662 Location: Adelaide

Back up for sale again. Buyer fell through.

Thanks for that. I found one. Now i'll be selling my .82 housing. Cheers.

Wanted: GT3582R (GT3540/GT35) 0.63 rear housing Extra Info: Must be T3 flange and 4 bolt 3 inch exit Here's my 0.82 housing (on the right). Contact Details: Reply or PM or MSG/Call 0416 143 662 Location: Adelaide Delivery & Conditions of Delivery: I can cover the cost of postage.

sold

Sold pending payment

Sold pending payment

For sale: Beer R - Rev Limiter Item Condition: Good. I never got around to using it. Price and price conditions: $240 delivered Extra Info: This is Bee*R’s popular two-stage ignition cutting rev-limiter. It is used to prevent damage arising from over-revving your engine. Part of the reason for its popularity is the large flames and loud bangs it produces from the exhaust when active! The way in which it works differs from the factory rev limiter in that it is an ignition cut, as opposed to a fuel cut. The reason for this is because if an engine (particularly turbocharged) regularly hits a fuel-cut rev limit (such as in high performance driving, or particularly drifting) engine damage can arise due to the lean condition produced when the original ECU shuts off the fuel pump. The BEE*R rev-limiter allows fuel to pass into the engine still, limiting engine speed by disabling the ignition signal. The Bee*R rev limiter is fully adjustable in 500rpm increments, for safety reasons allowing only a lower rev-limit to be configured than standard. If you have spent a lot of money tuning your engine, or are running at high RPM’s for extended periods of time, it could be recommended to run a lower rev-limit to prolong engine life. Both Formula 1 and JGTC cars use ignition cutting rev limiters, so it is a fully race proven concept. The Bee*R can also be used as a “two stage rev limiter”, as an aid for launching your car. The Bee*R is configurable for two different rev-limits. A lower rev limit can be activated by a switch, the handbrake switch often being used. This configurable lower limit, can be set to the optimum RPM to launch your particular car from in 500rpm increments. When the handbrake is released, the usual rev limit comes into action, allowing quick launches, and full performance down the strip. The Bee*R rev-limiter has another final neat feature. The gain control knob allows you to adjust the frequency of the ignition cut. This in turn changes the frequency and sound of the flames and bangs from your exhaust! Red wire: 12V+ Black wire: Earth Yellow wire: RPM Signal Green wire: Ignition signal White wire: 2 stage ground switch 4Cyl = Cut Grey Wire Rotary Engines: Cut Brown Wire 6Cyl = leave all wires intact. Pictures: Contact Details: Reply or PM or SMS/Call 0416 143 662 Location: Adelaide Delivery & Conditions of Delivery: Delivery included

Price change........ Now $280 delivered with a free boost gauge!!

For sale: GReddy Profec B Spec II Electronic Boost Controller - Silver Item Condition: 2nd hand, works perfectly. Price and price conditions: $300 delivered Extra Info: - Built in Boost gauge (kPA or PSI) - 2 preset setting - (Lo. & Hi.) Set % - to increase boost - Gain % - wastegate response adjustment - Start Boost - initial boost response adjustment - Warning point, warning limiter, peak-hold/last boost - Compatible with Remote Switching System (to switch from Lo. to Hi) Pictures: Contact Details: PM or Reply or Call/SMS 0416 143 662 Location: Adelaide, SA

SOLD Thanks

For sale: Genuine Garrett GT3582R (GT35, GT35/40 etc.) 1.06a/r Exhaust Housing Item Condition: Used, good condition. Price and price conditions: $200 plus delivery Extra Info: T3 flange, 4 bolt 3 inch outlet Pictures: Contact Details: Reply or PM or SMS/Call 0416 143 662 Location: Adelaide SA Delivery & Conditions of Delivery: Postage should be under $20

::SOLD::