RxDrift

Genuine GT35R turbo now $1000ono delivered!!!

Pressure reg sold. Everything else available still.

For sale: Genuine Garrett GT3582R ball bearing turbo. 600-700hp Item Condition: Great. I am selling because I have decided to get a slightly smaller turbo. Price and price conditions: $1100 delivered Extra Info: T3 with 4-bolt 3inch turbine outlet, 4inch entry 2.5inch exit compressor. Polished 0.7 A/R compressor housing, 0.63 A/R turbine housing. CHRA serial number 706451-5015 Pictures: For sale: Braided lines for turbo Item Condition: Lines and fitting are new and un-used. Price and price conditions: $60 delivered Extra Info: -10 oil drain line with 45deg fitting. -6 oil feed line. Pictures: For sale: SARD Standard Type Fuel Pressure Regulator Item Condition: Came with a fuel rail and I don't need it. Price and price conditions: $80 delivered ($220 new from GCG) Extra Info: -6 fittings. 200-800kpa Pictures: Contact Details: Reply or PM or msg/Call 0416 143 662 Location: Adelaide

Back up for sale again. Buyer fell through.

Thanks for that. I found one. Now i'll be selling my .82 housing. Cheers.

Wanted: GT3582R (GT3540/GT35) 0.63 rear housing Extra Info: Must be T3 flange and 4 bolt 3 inch exit Here's my 0.82 housing (on the right). Contact Details: Reply or PM or MSG/Call 0416 143 662 Location: Adelaide Delivery & Conditions of Delivery: I can cover the cost of postage.

sold

Sold pending payment

Sold pending payment

For sale: Beer R - Rev Limiter Item Condition: Good. I never got around to using it. Price and price conditions: $240 delivered Extra Info: This is Bee*R’s popular two-stage ignition cutting rev-limiter. It is used to prevent damage arising from over-revving your engine. Part of the reason for its popularity is the large flames and loud bangs it produces from the exhaust when active! The way in which it works differs from the factory rev limiter in that it is an ignition cut, as opposed to a fuel cut. The reason for this is because if an engine (particularly turbocharged) regularly hits a fuel-cut rev limit (such as in high performance driving, or particularly drifting) engine damage can arise due to the lean condition produced when the original ECU shuts off the fuel pump. The BEE*R rev-limiter allows fuel to pass into the engine still, limiting engine speed by disabling the ignition signal. The Bee*R rev limiter is fully adjustable in 500rpm increments, for safety reasons allowing only a lower rev-limit to be configured than standard. If you have spent a lot of money tuning your engine, or are running at high RPM’s for extended periods of time, it could be recommended to run a lower rev-limit to prolong engine life. Both Formula 1 and JGTC cars use ignition cutting rev limiters, so it is a fully race proven concept. The Bee*R can also be used as a “two stage rev limiter”, as an aid for launching your car. The Bee*R is configurable for two different rev-limits. A lower rev limit can be activated by a switch, the handbrake switch often being used. This configurable lower limit, can be set to the optimum RPM to launch your particular car from in 500rpm increments. When the handbrake is released, the usual rev limit comes into action, allowing quick launches, and full performance down the strip. The Bee*R rev-limiter has another final neat feature. The gain control knob allows you to adjust the frequency of the ignition cut. This in turn changes the frequency and sound of the flames and bangs from your exhaust! Red wire: 12V+ Black wire: Earth Yellow wire: RPM Signal Green wire: Ignition signal White wire: 2 stage ground switch 4Cyl = Cut Grey Wire Rotary Engines: Cut Brown Wire 6Cyl = leave all wires intact. Pictures: Contact Details: Reply or PM or SMS/Call 0416 143 662 Location: Adelaide Delivery & Conditions of Delivery: Delivery included

Price change........ Now $280 delivered with a free boost gauge!!

For sale: GReddy Profec B Spec II Electronic Boost Controller - Silver Item Condition: 2nd hand, works perfectly. Price and price conditions: $300 delivered Extra Info: - Built in Boost gauge (kPA or PSI) - 2 preset setting - (Lo. & Hi.) Set % - to increase boost - Gain % - wastegate response adjustment - Start Boost - initial boost response adjustment - Warning point, warning limiter, peak-hold/last boost - Compatible with Remote Switching System (to switch from Lo. to Hi) Pictures: Contact Details: PM or Reply or Call/SMS 0416 143 662 Location: Adelaide, SA

SOLD Thanks

For sale: Genuine Garrett GT3582R (GT35, GT35/40 etc.) 1.06a/r Exhaust Housing Item Condition: Used, good condition. Price and price conditions: $200 plus delivery Extra Info: T3 flange, 4 bolt 3 inch outlet Pictures: Contact Details: Reply or PM or SMS/Call 0416 143 662 Location: Adelaide SA Delivery & Conditions of Delivery: Postage should be under $20

::SOLD::

For sale: SSR Vienna Dish (Work Euroline) - 17 x 8/9 +37 - 4/5 Multi Stud (114.5) Item Condition: Used. Some gutter rash. Missing 2 of the centre plates. Price and price conditions: $600 Extra Info: I recently repainted all of the faces silver. Pictures: Contact Details: PM or SMS or Call 0416 143 662 Location: Adelaide, SA Delivery & Conditions of Delivery: $50 extra to courier, no tyres if delivered.

SOLD!!! Deposit taken.

price drop. $13,500!!! Make an offer!!

bump

Price drop. $14,000 ono

bump

bump

bump

For Sale 1994 Nissan Laurel C34 Medalist V Turbo (LX Selection) Specs on the model here ----> Nissan Laurel C34 INFO This is, as far as I know, the only fully complied, registered and legal C34 Laurel in Australia. It has gone through the strict inspections at Regency in South Australia and passed. Perfect for someone who is looking for a very unique and legal import that can be used as a daily driver or for some spirited driving through the hills. Mechanical: RB25DET MANUAL (from an R33 Skyline), was originally an RB25DET Auto Engine and Gbox have only 130 000kms (Odometer 212 000km) New Bilstein Suspension all around Exhaust with canon muffler Nizmo 2-Way LSD Short shift kit on Gearbox ABS Work 17inch rims Front fog lamps Complete option bodykit w/ moulded front lip, side skirts and rear pods Registered until September 2010 Interior: Top of the range Medallist model Leather interior Woodgrain dash Electric windows, mirrors, seats Electronic climate control Alpine CD player EcuTalk consult computer, Blue screen (Reads everything directly from the computer including fault codes. Also computes fuel consumption, 0-100 and 1/4mile times etc.) more info here ----> ECUTalk INFO Central locking w/ Australian Standards immobiliser and Alarm system Airbags Tinted windows Black two-tone paint Spare parts: Rear bumper – current one has some bumps and scratches from when the car was used in Japan. New one will need to be painted to match two-tone paint. Gear shifter woodgrain surround – current one was modified during manual conversion. New one will also need to be modified. Nissan FAST Software - this software allows you to find the Nissan part number of ANY part of the car, especially helpful because this car is so rare. It also has details of almost every Nissan released in Japan. Condition: This car is in great condition for its age and only has a few blemishes. Front driver and passenger seats have slight fading and cracking from sun damage. Rear seats are in great condition. Boot used to have a spoiler but has been removed and the mount holes are currently plugged up with rubber grommets. Paint is in great condition although there are some stone chips, as expected on the front, and the bumps as mentioned on the rear bar. Dash lights are a little dim during the day. Pictures: Price: PRICE DROP $14,500neg. No swaps. Finance Available, contact me for details! Location: Adelaide, South Australia Contact: PM, Reply or call 0416 143 662

bump price is negotiable.