guru_ray

My solution to the Active LSD and it's problems was to pull it out and put in a standard diff(shimmed). If you do this you will have two speed sensors hanging loose, one of these will fit in the front of the standard diff. If you then cut the other one and splice the wires into the sensor loom you are using you will still have ABS and no fault codes. End of tread. Ray

I am about to do this job myself. After doing a bit of research I am going to use the Nolathane bushes. Part # 49154 and if you want to do diff mount #49162. The good thing about these is that you don't need to remove the outer sleeve from the cradle at all, just cut/burn out the old rubber. grease up the new bush and push in. No ten bizillion ton press needed. http://nolathane.com.au/install_guides/50-9154.pdf Fitting guide above. Will post results after.

Any ideas on how test these for correct operation, is there a resistance test?. Ray.

Ok wheel speed sensors, where the hell are they?. I would have thought that they would be on the hubs, with a magnetic reader and a magnet spinning with the hub? No wiring going to the hubs at all. There are two sensors of some sort on the back of the diff itself ether side with two wires each. I followed these wires and they go to the Hicas Module. Stupid diff. On a side note I have a hicas lock bar. The wiring for the hicas does no need to plugged in to make this diff work does it? Ray

Thanks I have read every thing there all the links. Codes are 75 and 62. Cheers Ray.

Stock ECU is in the car now. Codes I have are 75 which i believe to TPS And 62 which if the same as the Attessa codes would be front and rear right G sensor???? I don't think the GTS-T has G sensors??? Will be going with apexi powerfc later and splicing the wires for the TPS, If I get the A-LSD working that is. Ray.

Deano45 Dead link for me?. I have studied all the links in the sticky at the top of this section of the forums if that was what you were referring to. I am trying to read the codes so I can get this thing working properly, I am single spinning at the moment. And have two codes one is TPS the other I don't know. Thanks all help appreciated. Ray.

OK, This seems to be a hard question. If someone out there wants to do me a favour? Moanie suggested in one of her posts she knew what one of the the codes was on her A-lsd module. If somebody wants to send a PM to Moanie ask if she can post the codes here, if she has them. Moanie if you don't have codes for the A-Lsd module where did 'read' the TPS error? I cannot send personal messages until i have made 10 posts. I don't see the point in spamming threads just so I can send a message. If the answer is out there lets get it up here! Ray ps. if you send a message to Moanie post you have done so, so she don't get a mailbox full of spam.

Hi all, I have looked far and wide but i still can't find what I am looking for. Does anyone have a list of the codes that the control module for the A-LSD flashes out when an error is detected?. On the underside of the module in the boot is a light that flashes codes in the same way that the ECU does. Edit 'my car is a 1993 r33 GTS-T manuel. Thanks Ray.