joshm35

Plugs are the same with 350z seats. Only wiring that needs to do is add a plug on the passenger side as the plate sensor id hard wired.

The gasket (rubber) comes built into oil filters z445.

http://www.importmonster.com.au/view?url=http://page9.auctions.yahoo.co.jp/jp/auction/k217461415&thumb=http://auctions.c.yimg.jp/images.auctions.yahoo.co.jp/image/ra181/users/1/7/0/5/rath_1217_0830-thumb-146495754896359279290334.jpg&title=167%20M35

There used to be a few that did it but not sure if this is still getting done. No point spending up to 300 to covert something useless

www.importmonster.com.au

Been a big weekend with installing bits on the M35. - swapped over my r34gtt front pads (nismo) - installed and rewired side mirrors - installed moshimoto alloy radiator - installed scotty cooling mod - installed nismo thermostat - replaced lower radiator hose - replaced driverside wiper. Future mods for secured parts - gearbox swap (shift kitted) - walboro 255 fuel pump - full 3 inch exhaust (scotty front pipe, fujitbuso legalis catback) - plenum spacer - Adaptronic with cable throttle set up - 1000cc injectors - replace rear door - daleo intake - tune.

Yes i would get new bolts so you know they wont snap. They are inexpensive and save alot of messing around if you do snap em. I learnt the hard way and did the same due to having to do it twice with it shifting it place due to no gasket goo.

http://www.ebay.com.au/itm/152205333254

Oil will cause more of a smell than catching on fire. Main thing is if you leave it for a while to monitor oil levels. If you do it now it may take up to 2 hrs to complete and make sure you use gasket glue to hold it in place (yes others will say you don't need to but they got lucky). This will allow you to get under the heater hose without it falling out. Be careful tighten the old bolts as they have been heat perished and will snap of over tightened.

I would say that they use the tie down points. If not there may be a thread point you can use and drill a small hole in the floor panel and use a floor type harness point.

Is it an actual legalis or just the Fujitbuso muffler as if it was the legalis r than the chamber will allow the car to be as soft as stock.

Oil down turbo side is cam cover gasket

Never had any issues when i had it on mine.... Air flow is feeling very restricted as of late

Check the voltage going to the AFM.

Ryan does mine in cleveland (Ultimate Autocare)

Yours sounds like afm. Its almost like one of the pins is dirty/not making full contact inside the plug. Assuming this happened after ypu installed the intake and afm was plug was unpluged?. What about 02 sensor.

Looks heaps better. I want to get some of this wrap and do the interior door handle strips

I had this on mine and worked well (sold to josh geering). The stock runner hose as far as i know wont fit from the top of my head due to shape of bottom section.

Get a 2nd hand one from a wreck. If it fails you open the hatch and use the manual open latch.

Love the red.

A pic of my RX

Some people. .....

For someone interested in possibly buying stock of them. Plus i love to annoy members.... you're welcome.

I got it from yahoo auctions in Japan. Yours may have had the screen from factory as mine had the dvd rom in that area.

B