Dave.TAS

Got a wiper switch mate? R32

Could have pm,d me and had a bolt on solution for cheap

I want to sell my last rb20 block, head, crank and Rods, and sump. 100 bucks take it away I have an rb25 turbo outlet pipe but called tobs and didn't want it like 3 weeks ago

Turn boost down until u make a metal intake pipe, the pipe on that car was soft as last time I saw it

The turbo in the photos is not a hks 2530?? I make 20psi at less than 3500 revs in my skyline, and it's definately not laggy

Wrong thread dude, that's under 260??

Tj just use the standard fan

pm sent

I know of a r32 4 door going reasonably cheap, is complete with engine, rego etc etc. Send TJ a message and ask, 0437 798 034

0439 484 095, his name is Tom, tell him Dave said you have a 32 shell for sale Not sure what he wants for it but its in reasonable condition, half primer half bionic blue, not sure on interior. Its in devonport.

DJRIFT on here has a pair for sale, send him a pm or find the for sale thread in the tassie section

Peter, the jumping problem you described can also be a loose or worn ball joint in the lower control arm, seen examples of slightly loose ones change the wheel alignment by over 30mm

It doesn't unless you remove the oil cooler and pour it out. Also most oil thermostats don't completely block of The oil cooler so it should start to fill as soon as you crank the engine. When fitting new oil cooler kits I always disconnect the ignitor and fuel pump fuse and crank the engine for a while to pre fill the lines and cooler so the engine sees oil sooner rather than later when u fire it up properly

You enough have low oil pressure or your oil is too thick. Put some 5w30 in it and see if tha helps.

I've had 3 rbs spin on number six yep.

Hey autumn I have a safc2 for sale, 250 delivered as new condition with all wiring etc. This will allow you to tune your fuelling and run a z32. Also if your relying on a drift brand air fuel ratio gauge to tell you what the cars tune is like, your headed in the wrong direction. One of those gauges won't tell you much at all, you need a proper wideband a/f monitor.

Devonport, ulvy, launy

As per title Dave 0409 631 092

Relay is in the boot between the two tail lights, behind the grey trim panel

Does anyone have a Nistune or consult cable I can borrow?

Hey, I have nistune in my r32 with rb22 (forged and n1 stuff) and new hks 2530, gtr 440cc's, walbro and a z32. the nistune'd ecu i have was from a car in qld or nsw with rb20 and a hks 2530, 440s, z32 and a 040. Question is, if i take it to my workshop and plug it in to any old nistune software, can i adjust the current map or do i have to start from scratch, seeing as the tune was made on someone elses computer/licence etc etc. Thanks

Also have an rb20 one, 10 bucks Dave 0409 631 092

I have an mint condition rb25 one with bolts, 50 bucks

Wrong flange won't bolt up without ugly adapters

They're mint, as new.