Stan

What ratio is the diff?

Do you have pictures and part numbers?

HI, What oil pressure did you have and what did you drop it to? My N1 pump is putting out 8 bar (120psi) at 3000rpm. I will have to reduce pressure as well.

Hi Tony, How many K,s has the diff done? Stan

Pedestrians looking when you drive past Loud. My machinist has heard the noise and agrees that it is piston noise. As loud as stuffed lifters. The noise is VERY loud when cold and only a bit quieter when fully warmed up. The equipment is machine shop equipment. Measurement taken 10mm from the bottom of the skirt. I will check the measurement half way up the skirt tomorrow. I am trying to decide if I should fit new pistons with longer skirts or maybe get another RB block and rebore it with tighter clearances

Do you know the piston to bore clearance? I have just fitted a rebuilt RB30/25 with Mahle pistons and the motor has very loud piston noise. After 100klms with no change in the noise, I have pulled my motor out again and rechecked the clearances and found them to be at .003" as my machinist had set them. I have since heard that the pistons are race only pistons and not street suitable, that they are always noisy and should have less clearance. Do you know if this is correct?

Hi Matt, I'm in the market for a steering wheel boss for a hicas R33 GTS. How much do youy want for yours? Sorry I don't have anything to swap. thanks Stan

I got an R34 box as it was all I could find at the time. Push type is cheaper. For your conversion you need the wiring harness from the gearbox up to the fuse/relay box on the drivers side inner guard for the reverse lights to operate. For the speedo to work you need the manual speedo gear drive in the box and a manual speedo head or it may be easier to buy a complete cluster second hand. Dont ask me why Nissan have a manual and auto speedo head, but they do. Hope that helps. Stan

Yes it does if you use the R33 gear lever, push type clutch and slave cylinder.

as T04GTR said, all you need is the gear lever and pull type clutch. everything else bolts straight up.

Yes you can. Make sure you get the flywheel machined. Even if the surface looks OK it is often dished slightly from heavy use.

I am about to fit an R34 box into my 33GTSt. (Auto to manual conversion) Can I use an R33 GTR flywheel with a pull type clutch?

The Mines Dump Pipes have been sold. Thankyou. Stan.

I wish to purchase these parts. I'm still waiting for you to PM me Thanks Stan

Hi, I need a gearbox and allparts required to convert from auto to manual. Can you supply them and how much? Thanks Stan [email protected]

Bilstein Shocks have been sold Thanks Stan

Hi, I'm chasing the metal intercooler pipe between the Twin Turbo pipe and the Intercooler on the passenger side and an R33 metal power steering resevoir. Can you help? Thanks Stan

Hi, Do you have for sale the metal pipe on the passenger side between the Twin turbo pipe and the intercooler? I'm also chasing an R33 metal power steering resevoir. Thanks Stan

Hi Sasha, I need the metal intercooler pipe and bracket on the passenger side that goes between the rubber hoses connecting the Twin Turbo pipe to the intercooler. I also need a metal bodied R33 GTR power steering resevoir. (bolts to the left shock tower) Can you help? Stan [email protected]