93WIZ

have now sold the R33 and bought a 2001 ADM S15.

Located on the Gold Coast and 6 months rego

This is more of an EOI on my 1995 Nissan Skyline R33 GTS-T, i have owned the car for 3 years and have done all the work on it, making sure it is all done perfectly with quality parts. 500kms ago i had the head rebuilt with cometic street pro VRS kit, all surfaces machined and fitted ARP head studs too. find below some of the modifications. looking for $13,500 ONO and swaps are welcome would consider S15, 180sx with cash, etc etc ENGINE / TRANSMISSOION: * RB25DET with 165,000 kms very healthy motor * dyno tuned 3 weeks ago at 373HP on 17psi. * FMIC * 740cc injectors * freddy plenum * BRISK performance spark plugs * walbro GSS-342 fuel pump * all new vacuum lines * nissan thermostat replaced 500kms ago * gates racing timing belt, and pulleys replaced 500km ago. * water pump replaced 500km ago * cometic head gasket 500km ago * ARP head studs 500km ago * full head rebuild with receipt 500km ago * stainless steel high mount manifold with screamer * TIAL 38mm wastegate with 1 bar spring * Kinugawa TD06-20G turbo 500km old * custom braided lines for turbo * 3" stainless exhaust, high flow cat. * o2 sensor recently replaced * always used fully synthetic AMS oil 10W-40 * KN oil filter * DRIFT pod filter * aluminium radiator * blue silicon rad hoses * apexi power FC with hand controller * Greddy profec B series ii boost controller * turbo timer * locked Diff SUSPENSION/ WHEELS: * near new GREDDY coilovers all round * rotoa wheels * Achilles tyres brand new 50km ago * new QFM A1RM brake pads front and rear * cusco strut brace * KKR rear camber arms * recent wheel alignment INTERIOR/EXTERIOR: * m spec body kit * HID head lights * LED parkers * LED number plate lights * R33 series 2 dash surround * new leather gear boots with red sticthing * pioneer head unit * new jdm gear knob * JL audio rear speakers * sony xplode front speakers * momo styled deep dish steering wheel with HKB boss kit * carbon fibre boot lip BAD POINTS: * small amount of rust in both rear guards * the roof has some small patches where clear is visible Thats all i can think of at the moment, im sure there is alot more i have forgotten to mention, i have receipts for pretty much everything done to the car and it is serviced every 5,000 kms. the car is in great condition inside and out, i dont really want to sell but if i get my price or a good offer as a swap then i will. inspections welcome, no test pilots or time wasters please. for any questions PM me on here or call on (Contact Seller) car also comes with rego

1995 Nissan Skyline R33 GTS-T, i have owned the car for 3 years and have done all the work on it, making sure it is all done perfectly with quality parts. 500kms ago i had the head rebuilt with cometic street pro VRS kit, all surfaces machined and fitted ARP head studs too. find below some of the modifications. looking for $13,500 ONO and swaps are welcome would consider S15, 180sx with cash, etc etc ENGINE / TRANSMISSOION: * RB25DET with 165,000 kms very healthy motor * dyno tuned 3 weeks ago at 373HP on 17psi. * FMIC * 740cc injectors * freddy plenum * BRISK performance spark plugs * walbro GSS-342 fuel pump * all new vacuum lines * nissan thermostat replaced 500kms ago * gates racing timing belt, and pulleys replaced 500km ago. * water pump replaced 500km ago * cometic head gasket 500km ago * ARP head studs 500km ago * full head rebuild with receipt 500km ago * stainless steel high mount manifold with screamer * TIAL 38mm wastegate with 1 bar spring * Kinugawa TD06-20G turbo 500km old * custom braided lines for turbo * 3" stainless exhaust, high flow cat. * o2 sensor recently replaced * always used fully synthetic AMS oil 10W-40 * KN oil filter * DRIFT pod filter * aluminium radiator * blue silicon rad hoses * apexi power FC with hand controller * Greddy profec B series ii boost controller * turbo timer * locked Diff SUSPENSION/ WHEELS: * near new GREDDY coilovers all round * rotoa wheels * Achilles tyres brand new 50km ago * new QFM A1RM brake pads front and rear * cusco strut brace * KKR rear camber arms * recent wheel alignment INTERIOR/EXTERIOR: * m spec body kit * HID head lights * LED parkers * LED number plate lights * pioneer head unit * series 2 dash surround * new jdm gear knob * JL audio rear speakers * sony xplode front speakers * momo styled deep dish steering wheel with HKB boss kit * carbon fibre boot lip BAD POINTS: * small amount of rust in both rear guards * the roof has some small patches where clear is visible Thats all i can think of at the moment, im sure there is alot more i have forgotten to mention, i have receipts for pretty much everything done to the car and it is serviced every 5,000 kms. the car is in great condition inside and out, i dont really want to sell but if i get my price or a good offer as a swap then i will. inspections welcome, no test pilots or time wasters please. for any questions PM me on here or call on (Contact Seller) car also comes with rego

wow, being a welder/fabricator i must say that is a terrible weld especially from tomei! would expect them to have certain testing procedures before sending products out to ensure there are no returns. hopefully there is no faults with the next one, cool build thread too!

Took the car for a spirited drive through the gold coast hinterland last saturday with a few of my work friends and my best mate

UPDATE: i had the car on the dyno a few saturdays ago, all tuned up with standard throttle body back on, new thermostat and TPS set up perfectly. the car performed very well and im happy with 373HP at the rears on 17psi, i will be getting a new CAS in the next few weeks and putting it back on the dyno to squeeze a bit more out of it as my current CAS is playing up at about 6300 RPM to rev limiter, not a big deal by any means.

UPDATE: So the car went off to the dyno a few saturdays ago, and as usual the only thing i didnt replace was what failed on me, the thermostat was stuck open and not getting hot enough to push power through, also my TPS was reading to low V and had to be modified so i could rotate it more to get the correct Voltage. SO..... on sunday i put a genuine nissan thermostat in and modified the TPS mount so i could rotate it more, i set the TPS to .38V when car is on accessories only...seemed ok so i turned the key and more problems occured....the car is idling at 2,000RPM.... not sure why so i turned it off, replaced all vac lines and certain fittings...still made no difference....so i took the AAC valve off, cleaned it and went to put it back on when i found one of the mounting bolt threads were stripped.....could have been a problem with the high idle also ??? so i have to helicoil that tomorrow and put it all back together to see if it is still idling high.. if so..... does anyone know of a certain procedure that needs to be done when putting a TPS back on? such as foot to the floor (throttle completely open) etc??? any help would be appreciated. for now, here are a few pics, also got a 200mm dildo shifter.

bit more of an update, got all my parts and picked up the head fresh from being serviced, so happy with my cometic VRS kit and their MLS head gasket looks unreal! anyway here are some pics! will hopefully get it all back on the car in the next few days and then to get her on the dyno and hopefully pull some decent numbers!

UPDATE: This is now how the engine bay looks dropped the head and intake manifold off to works engineering where he will be servicing the head and machining all surfaces. Gates racing timing belt kit is on the way along with new ARP head studs and a COMETIC head kit.

nice build mate lovin the wheels!!! if i could give any advice before you put the motor in i would recommend doing certain things that are easy to get to while the motor is out, if you plan on having the car for a while and putting some decend boost through it then a cometic head gasket along with arp head studs would be a worthwhile investment, water pump, and of course all new gaskets. you can get a cometic gasket kit off ebay for less than $300 i think? thats just my opinion, cant wait to see the thing finished! good luck.

UPDATE! not a good update, but still an update none the less. I had one job left to do on the car which was to apply thread sealant to a inlet manifold bolt that was leaking a bit of coolant, so i took the bolt out.....cleaned it, cleaned out the female thread on the head of old sealant as best i could, applied new sealant to bolt and as i was tightening the bolt up with a 1/4" ratchet i hear a loud CRACK................thought it may have been the ratchet slipping a tooth or something as the bolt wasnt tight at all......tighened the bolt up, let the sealant set for a while and put coolant in the system.....this is where i found out what the crack was....it cracked the female thread on the head....major FML situation...so i have started taking everything off to get the head off.... While the head is off i will be getting it serviced along with a new cometic gasket set and ARP head studs. Atleast ill be able to run more boost knowing i have a steel head gasket in there....anyway here are some pics. cracked thread: 1 hour later: also have exhaust manifold and all belts off now....hopefully the block is still good and the head wont need much work.

i have heard a few good things about the Rossi welders you can get from a machinery place in sydney, they are under 1k and come with everything you need incl 50amp plasma cutter. im looking at getting one based of the reviews i have read on them.

The T04E was running 310HP at 1 bar, i checked the plugs and they don't show any signs of running lean on idle only. I will be doing mainly highway driving for about 1 week until i can get it tuned.

i have an urgent question for you skyline enthusiats! My car was tuned and running perfectly to suit the old T04E turbo, am i able to drive the car with the new kinugawaTD06 20G turbo without getting it tuned for a few weeks? It starts and idles fine.