Jump to content
SAU Community

Bsa

Members
  • Posts

    1,316
  • Joined

  • Last visited

  • Feedback

    100%

Everything posted by Bsa

  1. Might be acl cast items I did tones of research when thinking of building a BMW motor they make a 82mm piston with the same rod height as most rb engines
  2. I can conferm gtst will fit gts4 well rears anyway fronts going in tomorrow
  3. Rb20s are under rated they are a wicked little motor you could and a 20 installed run stock tune 25 turbo and just drive it for around 3 to 3.5k maybe less keeps money in your pocket for if you want to build the rb23
  4. I think it would be a waste of money but as Andy said can be cleaned up but they are fairly good I only clean them when I make them external gate
  5. Seeming you have had the car for so long would be a shame to sell it broken rb20 can be bought cheap and they are fairly solid little things then if you still want a gtr sell it
  6. Def would but boost controll is the issue depends if your prepared to run 20 pound all the time
  7. I'm out of time and money needs around 2 g and it's done I'm devo plus someone stole all my gauges and a stainless manifold the other day so that puts me back there to. The plan was to keep the car sell the 26 buy a cheap 25 and I could finish it. My daily shat a motor today and tow costs and repairs near left me a g out of pocket with no car all while trying to tow a car so I'm stuck. If the 26 sells it will be finished if not will sit there till I have the money
  8. Kandos as said should only be used for external gate
  9. Sure do even when done yourself
  10. Iv always mounted coolers on a slant in my eyes it will restrict airflow to a extent meaning more time to cool the fins and tubes or bars also when on a skyline with not much room allows more surface area to be open before the bar support
  11. Sounds like clutch is gone
  12. You will loose a lot down low your options are plazmaman or custom made
  13. What spring is in the gate? I had a 7 pound spring in my gate running 18 pound with a mbc once I put a highter spring in lag was reduced drastically
  14. I only have comp results from the blown hg it was leaking into the cylinders so I have no results if I can get a flywheel I can then comp test it
  15. No more swaps just want a car to drive not push
  16. How about a swap pete haha car didnt sell motors coming out
  17. Up for sale is my project was in a e36 BMW but am no longer going through with the project. It's got a brand new Nissan headgasket and has bronze guides. Motor was leakdown tested and seems to be in near perfect condition. Sale is for full motor needs gaskets Contact 0449831518 Also it is out of a 32 gtr
  18. All but the same just coilpacks as said the ecu should run the engine fine I would think
  19. If you look underneath you will see a spot near the rear cradle pull out a tape and mesure what room you have then go shopping
  20. As if you can't stock and most jap exhausts have a mid muffler need a offset one it fit most times
  21. Da da da another skyline bites the dust. Sorry to hear mate
  22. It may be possible to cut it off just after the injectors and weld a plate on otherwise Iv looked at doing this myself and a adaptor plate made properly will work just fine
  23. Put a mid muffler just up from the diff there should be a space for it
×
×
  • Create New...