modb
-
Posts
8 -
Joined
-
Last visited
-
Feedback
0%
Content Type
Profiles
Forums
Events
Gallery
Media Demo
Store
Everything posted by modb
-
I have a wide band in the car and its not leaning out, and the dead times were corrected. When it dies there's no warning, and the A/f ratios look fine, that's whats random
-
The injectors have been adjusted for, and air intake temp is turned off. And I also know its not plug and play, its just a lot easier then using NIStune in my personal opinion
-
Hey everyone, yesterday I wired up my Haltech Plug and play for my R32 Gtst with an rb25det swap, running 750cc intectors, topmount turbo, Haltechs MAP sensor (was running a used Z32 MAF with Nistune) And running an rb20det Engine harness without VCT pinned. My problem is that once the car gets warm and has been running for 10-15 minutes it will randomly cut all power and stall out, I got it to do it a few different times and i know its not losing fuel pressure because my FPR gauge had full pressure when it died, I was wondering if anyone had the same problem? The car was running previously with NIStune and didn't have this problem
-
You have a PM
-
Its an RB25det swapped into an R32 running an RB20 harness and ECU with NISTune, and when I unplug the brown bottom plug on my TPS the idle jumps up 500RPM. And as i said it was an RB25 S2 TPS with the idle switch built in. And when i use my timing light on it it has the CAS almost fully advanced to get the 15deg. The car also idles at 1000-1200RPM and when i unplug the TPS it jumps to 1500-2000RPM as well.
-
It has the stock exhaust and intake cam
-
It's not stock haha it has pistons, rod bolts, head studs, as of yesterday it has a cosworth head gasket, 750cc injectors, Greddy intake, Borgwarner 7670 1.22AR, Nistune, top mount manifold and lots of other goodies. But I guess what I'm wondering is whats the proper way to set the base timing with the RB25det S2 TPS, that has the idle switch built in.
-
So recently I've built my rb25, but it feels sluggish, I've noticed that the CAS is almost to one side and i always thought they were supposed to be in the middle. Can anyone tell me what causes the CAS to to not be centered i guess?