Mat Ackland

Hey bud, Have a similar low idle problem, its usually the bov, I have a greddy profec b and you can adjust the pitch and what not.id suggest you go revise your bosst controller setup because mine, the lineoff the boost controller ts onto my boost gauge line which is then td off that small fuel pressure line near the vvt connection. Then I have avacuum line going from top ic piping to the in on the greddy unit, then the out line goes to your waste gate right near the turbo, make sure you hve removed stock boost controller located near the power steerjng fluid resevoir and I just taped up that connector that you take off the stock b controller. Hope this helps bud!.

The groove that these clips go into are way lower on the shaft then this picture! Rb25det s1

Just realised that its really tight!!!! New bushing should be here tomorrow,i cant get my shifter outnow....please help!!!

Has anyone ever installed a HPI not HDI front mount kit. The piping that runs down the drivers side requires you to notch side brackt on re bar not only the front, cant find much out about this kit and came with sero instructions aaand cannot be located on the web! Any help would be great thanks!

Hey man, new to this site but quick question, my short shift kit screws apart to put a new white gasket, I took the end cap off the stock one with a heat gun, then installed it on the new one, fits in nice c clip is in but my banana clips sit 3/4" below the big hole, the square piece doesnt sit exactly right on the hole so I looked and it also came with a metal riser but it def wont reach the banana clips, I dont think the square peice really holds anything. Can you please help!!! Thanks