Damian-V35

They look damn good Sean

Bump. We gonna do this?

November is good.

I can't make it on the 7th - Bathurst weekend. Following weekend would be perfect

I'd be keen on this.

You're so gonna get defected, be careful.

Common misconception. The force required to flex or bend a straight bar is far less than that req'd to flex or bend a bar that has a premade bend in it. The bar in question in this instance has two radii in it so trying to flex it in either direction along those radii would have them fighting against themselves - as would be the case once installed onto the car.

Silver coupe GTV350 plates Narellan road 5 mins ago

I am with Just Car. Did it all online. Listed all my mods. Agreed value. f**k NRMA

I haven't been in the high end car stereo scene for about 10 years. But JL Audio used to make great subs. Dual 8ohm voice coils, wired in parallel drops the unit to 4 ohms. Then wire two of them in parallel for a 2 ohm box. Run if off a big alpine V12 amp.

Yeah Like Deep Dish said, it depends on your install. If you're good with working out volumes of complex shapes your could design and build your own box.

Saw a Silver Coupe parked in the Mt Annan leisure center carpark yesterday at about 2pm.

Where did you source your Karuma Z front bar from??

Just joined the FB page

Ok I understand now. I have the same BC's. I'd be modifying the bracket - cut out that vertical support, make a new one that would clear the Adjustment knob, and rewelding it in. But, in saying that I have access to tooling and a workshop and kickass welder to do it lol.