Search the Community
Showing results for tags 'ca18 rebuild'.
Found 1 result
-
Picked this up on the weekend for the track car, apparently approx 150ks and removed as a "runner", toying with the idea of attempting the rebuild myself - which I've never done but always really wanted to try. I've got a basic workshop, most tools, have done turbo/head/manfiold swaps and have over a decade experience with Nissan platforms etc etc so I have half an idea. Standard rods don't like going past 220 or so rwkw apparently and as my current motor is an original bottom end with some basic bolt ons I wanted something fresh anyway. Parts list will look something like this. Spool forged kit which has rods, bearings, pistons, rings, pins, metal head gasket etc. Headstuds New gaskets and hoses throughout. New oil and water pumps, timing belt, idler tensioner. Some tomei 256 cams I have sitting in a box brand new. Either new OEM or basic upgrade valve springs and some new lifters (lifters needed?) New balancer. Mild porting/port matching, nothing crazy, remove butterflies and possibly relocate injector ports. A GTX2860R I have sitting here which is new, could swap for 63 or 67? A little Tiual 38mm external gate. E85 Use my existing Nistune. Re-use existing oil cooler/intercooler/radiator fuel setup etc. I would want the basic bottom end balancing done, but once the initial weigh/measure/balance is done and you install the rotating assembly can you/should you then have it balanced as a short block? I've seen people do this with clutch attached also which seems odd, given the clutch could die tomorrow and be different. Same for the head, the guy I would have do some porting could likely do the valves/springs and clearances while he's there. leaving me cams/fit head to block which I'm OK with. With the 2860, I can't see it making more than 230-240rwkw, which is fine given I have no big plans for new gearsets or box swaps. 63 and 67 would go a little further but run the risk of hurting the box sooner - Box which is just a stocker with a nice clutch and fluid and no present issues. The alternative is I break the motor down, get all the parts, then deliver it all ready for assembly to my mechanic and collect assembled short block, an assembly head from the head guy, and do the final assembly and swap myself. I know it's not a "simple" task, but for those who have DIY'd a rebuild, would you do it again? What caught you out, anything else to throw in?
