LHD G35 Battery Cover Install [M35]
1. Remove the rubber that runs along brake cyl compartment
2. You'll need to trim off a strip of about 5mm from the top of the brake cyl compartment. I forgot to take a photo but we also sanded the edge after cutting, so there was no sharp bits.
3. Cut this little chode off from under the wiper too
4. You'll need to make at least one bracket to support the cover, as only one of the holes line up with the car to support it. Make more along the back if you're keen
5. Mock up the cover and mark out where the bracket will fit, then drill it out.
6. Test fit everything
7. Add a touch of paint to make sure the metal you've cut on the body doesn't rust. We just used touch up paint in a can that we sprayed into the lid and dabbed on with a paint brush.
8. Dun