Search the Community
Showing results for tags 'r34 problem'.
-
CAR won't start after POD SWAP So I originally had a BLITZ Pod filter on and decided to change it to a K&N Pod, and it was driving okay till about 20mins after a spirited run, at a red light it jumps into some sort of limp mode where I can't rev it over 2000Rpm even on Neutral. Had to make it home on 40kms. Engine light came on as well :S Its a R34 GTT Automatic 98 I have tryed resetting the ECU (battery disconnect) same results. I then swapped back my BLITZ Pod and now the car won't start at all, could it be my AFM ??
- 22 replies
-
- r34 afm
- air flow meter
-
(and 2 more)
Tagged with:
-
SKYLINE WON'T drive normally So after thrashing it down the road, my car went into a LIMP mode, now when I drive, it won't go over 2000rpm, even when parked I can't rev it pass 2000, it's like hitting a rev Limiter. So I suspected the AFM, spark plugs and Coils so, I cleaned the AFM (sprayed it down) and replace all my coils and spark plugs. Car starts up great but the problem is still there, what could it be? I have reset my ECU already. Before the limp mode starts, the car will drive fine till about down 3mins after it will just LIMP MODE the whole way, once I start my car again it will be normal for abit and then again LIMP My Skyline is R34 Triptronic. My engine light has always been on before this occur so I can't tell if another problem popped up so I have to check on that. I think also my A/T flashes before I start my car IMG_2500.MOV
- 13 replies