Search the Community
Showing results for tags 'temperature'.
Found 3 results
-
Hey all, just installed oil temp/pressure gauges in my car. Running a RB25DET NEO and was just wondering what it should be running at. Oil pressure is about 40psi at idle and a bit over 60 at higher revs from memory, this is when car is warm. Temp is around 85-90 degrees once warm and driving. Had a look in the service manual but couldn't find what they should be sitting at. Any info appreciated, cheers!
-
Hi all, I'm going to be upgrading my auto r34 set up and I'm going to install some new gauges. What do people think about prosport gauges ? Also to install the boost gauge can I use any of the factory wires/ connections ? Lastly does an engine oil temp gauge work for trans temp ?? I can't find any trans temp ones so I was thinking about using an oil gauge and sensor for it ? Cheers guys
-
Hi all, been a while since iv posted here. In a nutshell im running a haltech e11v2 piggybacked onto the stock ecu (was to run auto) and basically something is giving noise to the ecu via the temp sensor, it can vary up to 30 degrees cycling as often as every half second or so. This causes big idle problems from shutting off to blowing smoke etc. Iv tried running both the wires separately (not both at the same time) to the ecu and the noise is still there. Iv not been able to find anything out there with anyone having the same problem. Iv also tried a different sensor. The feed is getting 4.88V and the other is shared ground with the tps. That of which also gives me problems time to time. The noise is only there whilst engine is going and its not relative fluctuations to RPM. Any pointers would be appreciated! cheers.
