Series 1 And 2 Rb25det?

[calais25t]

I am currently changing my engine between shells and have not located an ignitor for the coil packs.

I am running an EMS ecu with map sensor and the loom goes straight into the coils packs and other engine other sensors from the ecu etc...

No ignitor to be found?

I have heard the series 2 engines have the ignitors built in to the coil packs is this true?

There is nothing were it would normally sit at the back of the coil pack cover.

I really need help with this as I need the car running again.

PS The engine was running in the other shell before I pulled it out so I have no idea ............Please help.

[R31Nismoid]

You are correct, the SII motor does not have the little black igniter box

So you are coming from a SI motor going to a SII?

[calais25t]

I assume its a series 2 engine although Im not sur.

Im changing the engine to a new rolling shell.

Is there a tell-tale sign thet its a series 2 engine?

Where is the igniter on a series 2 engine?

Bearing in mind Im running an EMS computor?

[boj01]

Ignitor is built-in to the coilpacks/ECU like you said. Look at the coil pack loom, if it has no provision for a ignitor, its a series 2 loom. Also look at the AFM plug if its S2. It should be a 3 pin plug.

[calais25t]

Dont run an AFM, I have no idea, it must be built into the coil packs as the computor wouldnt have it.