Jump to content
SAU Community

Recommended Posts

Hi all

I noticed lately my car has been squeaking in the engine bay.

Its only a soft squeak, and you can only hear it outside the car, even with the bonnet closed.

Its quite annoying and sometimes its there, sometimes its not.

I noticed that when I rubbed some wax on the main belt, it went away. But then it would come back again. I also sprayed some liquid on the belt, made it go away for a bit but then it came back.

It sounds like maybe a belt is rubbing against something ever so slightly.

Had a mechanic tighten the belt as much as recommended and check the belts. They are fine.

What could it be? A friend has recommended getting belt lubricant and spraying it.

Thanks all

Link to comment
https://www.sau.com.au/forums/topic/102506-squeaky-engine-noise/
Share on other sites

you put wax on ur belt?......

it could be a bearing in one of the pulleys more than likely. and by you spraying or waxing that stuff on it prob gets spun into the bearing giving it some extra lube but eventually gets spun back out because its not sealed thus noise comes back. Careful with putting stuff on your belt if it starts to slip from it to much it may wear out and snap..... jus try work out exactly where the sound is coming from and replace that part

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I mean, if you were to move the jacking points away from the original location, that is, away from the wheels and closer to the centreline of the car, then it will be more likely to overbalance and tip off the supports. Same as we talked about before. I was talking about moving for-aft. If the sill is bent outward or inward, then the car would obviously look unstraight from the outside. Hopefully that hasn't happened either. Again, you can do comparative measurements from the chassis rails to see if there is much deflection.
    • Can you elaborate what you mean with your first sentence? I meant move as in the bulge kinda seemed like it got pulled "outward" meaning it got pulled down and to the side with the jacking rail itself, so the load bearing bulge now sits lower than usual and is not level with the sill on the other side of the jack point. Either that or the jacking rail just got pushed in a good bit.
    • As well as being risky WRT tipping off anyway. Yeah, I wouldn't expect it to move. Just measure from the rear one to the front one on the good side, then measure that same length on the wrecked side. You will find the notches in the pinchweld, and the jacking pad. Just spray a spot of marker paint or something there.
    • but any other area than the bulge you are talking about will just cave in then? The front driver side is pretty bent so I don't know if that will work the way it is now. I can still kinda make out where that bulge is/was but it looks like the position of it also changed due to all the mistreatment? Hard to tell
    • Absolutely. Look very closely at the photo (of yours) that I took my second snip of. See how the sill is thicker material right behind the pinchweld, where the two notches are? That is the factory reinforced area for lifting. That pad is supposed to carry the weight. The factory jack (go look at it, and how it interfaces with the car at the pinchweld) shows you exactly how the load is carried from the car to the jack to the ground.
×
×
  • Create New...