Jump to content
SAU Community

Recommended Posts

  • Replies 717
  • Created
  • Last Reply

Top Posters In This Topic

Im actually super keen for this!! The later the better (late March) as need to get a couple of things fixed 1st on the Cefiro.....

yes it aint a Skyline but we all can't be cool and own a Cefiro :D

Ando

ill bolt std turbo's on "twoogle" to enter STD turbo GTR.....lets see how far they can be pushed....starting a small donation fund to pay for some stockers......

Edited by DiRTgarage

Well if you put the 2530's back on you would most likely win the aftermarket turbo section.

You're welcome ports and deviat.

Fixed the first post with the typo. 10% of all punches thrown on the day will be to 2rismo :D.

This looks like being huge guys. Firming up for the 11th.

There will be prizes for each category of:

Stock Turbo R32 GTST

Aftermarket Turbo R32 GTST

Stock Turbo R32 GTR

Aftermarket Turbo R33 GTST

Stock Turbo R33 GTR

Aftermarket Turbo R34 GTT

Stock Turbo R34 GTR

Wtf Adam? no Stock Turbo R33 GTST???

dohh...

booo...

To quote UAS directly:

We check the vehicle out before going on dyno including fluids etc and adjust tyre pressures for accurate reading. Will diagnose and advise on cars performance and anything we discover and at least two runs check boost, torque, power and air fuel ratio with a pic of car dyno print out and if they bring their own floppy disc we can supply digital version. ( If they forget we have floppy and can email it to them).

There is a good lunch shop which will be open until at least 12 although can stay open longer pending demand. Our shop will be open also and 10% minimum discount for SAU dyno day. Also our workshop for before and after mods to check on dyno pending demand for workshop and dyno numbers.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Latest round of updates on the car. I purchased and installed a SWS clutch slipper to help with 60ft times and got some second-hand good condition 275/40R17 Hoosier DR2 radials. Test and tune in November showed the tyres were an upgrade over my over 15 year old mickey Thompson's and I got a 1.8 second 60ft and pb et of 11.71 but even then, that run wasn't great due to rain and driver error (the event got called off 10 minutes later fast forward to the weekend just gone 25th of Jan and there was finally a break in the weather to let racing happen. The first run the track was slippery and only managed a 12.1@129 Second run the track was better and got a new pb et and mph: 11.54@131   Lith and I then worked out that I installed the previously mentioned clutch slipper incorrectly and its never been working, and I had just been dumping the clutch the entire time, we also noticed it was on street boost and not race boost. So I lined up for a third run with the car turned up in the first two gears, but the passengers side axle objected to clutch dumps and left the chat which stopped my weekend.   so there will be another attempt in the future once I replace the tyres as they rubbed and are stuffed now. but a low 11 should be on the cards.
    • Ceramic coating and heat shielding, you mean?
    • Turbos don't require pulling the motor apart so that's "easier". I would recommend the Nismo R3 turbos instead if you want to do stock twin turbo. It doesn't make as much power as the 2530s but it's only like ~50 whp off the mark and should have better response (ball bearing CHRA, slightly smaller turbo). A local that went with a Garrett G30 and 6boost manifold recently nearly burned his car to the ground after the hood insulator started melting and and burning so if you go single turbo I recommend doing a lot of research and validation work to make sure you don't do the same.
    • New rear lights, filler panel sprayed, cleaned and back together    before, during, after shots 😍
    • 100% is gyprock, I agree. Slip of the keyboard. Haha! I left my indicator bulbs out to save a bit of weight.
×
×
  • Create New...