Jump to content
SAU Community

Recommended Posts

Here are the parts, all are available separate and are negotiable. Everything works, is in good order and is cleaned and ready for you.

The RB30/25 is already sold.

Speedo, Tacho and all that jazz (showing very low kays) - $50.00

A/C "radiator" (I think its called a condensor - the thing that sits at the front) $40

A/C compressor, lines and all that stuff (no gas of course) $20

Heater box from behind the dash $20

Ashtry (with woodgrain for some reason) $whatever you like

RB25DE Computer . $40

Full R33 2 door dash with vents (no cracks, looks fine) $50

Glovebox $20

Surround for cluster $20

Kick panels (both sides) $20

Steering arms from both sides (with stock suspension in good nik - no leaks) they are 4 stud though) $100

Induction pipes/air box (whole thing) (suits turbo car or NA) $100

RB20 AFM $80

Radiator in A1 condition (no bent fins - same as a turbo one) $50

All plastics from around the front of a 33 (wheel arches and splash gaurds and stuff) $20

Brake lines (all of the metal ones) $20

Also have a VL N/A head, enjoy that as your new boat anchor!!! This is free to a good home .

Any questions you can PM or mail me.

***Also I have two RB20 turbos.****

One is a genuine low kay Rb20 turbo thats never been overboosted, the other has a chipped blade....

Good one - $150

"bad" one - offers around 50ish :D

Link to comment
https://www.sau.com.au/forums/topic/103186-r33-leftovers/
Share on other sites

Just after the air conditioning line from the compressor to the front condensor cylinder.

pm me

delivered to 2486 :rofl:

Also lower rear left hand control arm if you have it.

Link to comment
https://www.sau.com.au/forums/topic/103186-r33-leftovers/#findComment-1914092
Share on other sites

Just after the air conditioning line from the compressor to the front condensor cylinder.

pm me

delivered to 2486 :rofl:

Also lower rear left hand control arm if you have it.

Hey mate,

No worries, I've both those bits and will pm you later on. :)

Link to comment
https://www.sau.com.au/forums/topic/103186-r33-leftovers/#findComment-1914982
Share on other sites

All pms answered :)AFM is 100% working, and only out as my car uses a AFM'less map.

Its got about 75,000 kms on it, is clean and I'll refund out if it doesn't work :P

Link to comment
https://www.sau.com.au/forums/topic/103186-r33-leftovers/#findComment-1921596
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...