Jump to content
SAU Community

Recommended Posts

Hey Guys,

Im returning my S1 R33 car to stock and need the following parts:

Items to source still;

1. I have a R33 Custom Veilside Front Bar (silver) wanting to swap with a GTR or 400R Bar (pic attached) The mouth opening on the veilside is the largest as it is custom made.

2. Standard R33 Turbo (prefer S2) 45V5 with the u turn piece on the turbo (low KM)

3. R33 Air Bar Steering Wheel - Good Condition

4. Dash Console Tray (tray under the stereo).

5. Turbo to AFM Plastic thing

Items collected;

1. Climate Control Unit

2. R33 Stock Cooler with all the piping & hoses and clamps.

Thanks in advance.

Im in melbourne so i can pickup. Please PM me if you have any of the following parts. Will take stuff from interstate.

Cheers

AK

post-4729-1139088551.jpg

Edited by WLD747
bl4ck32 you have pm,but does anyone know if the r32 piping and setup is the same as the 33?

Nope, R32GTST is different, the intercooler outlet comes off the front, instead of the rear.

:( cheers :(

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If you have a Nissan from Japan and model year is from 2016 to 2024, just say you have an Infiniti Q50 4 doors... Why are telling you have an import?
    • It's definitely not firing order. But I think it should also be made clear that the output that gets fired is the one that corresponds to the input that was switched at the ECU. So you could scramble them up totally so that the numbers meant nothing, and so long as you had the inputs and outputs matched up, you'd be fine. The reason I make that point is that blanket statements about what it is supposed to be don't always hold out in a world where there's been 30 years for the wiring to have been stuffed with.
    • Hello, im asking about this guy - coil igniter on rb25det series 1 r33 s1 engine. I need to know if pins on coil side indicate coils itself from 1-6 or it’s firing order so pin nr1 goes to 1st fired spark plug:(1pin-1firing spark, 2pin-5order firing spark, 3-3, 4-6, 5-2, 6-4…)   photo: https://files.fm/f/k9pdug38uq
    • Remove it. Certainly from the hub face. I'm not in love with leaving it on the wheel assembly surface either - but if it is common to do so, then....maybe fair enough. It's not difficult. Just time consuming. For the hub face you just need a large enough block and suitable grades of abrasive paper to get it off flat. The same would be true of the assembly face. Just more time consuming, probably needing a lot more care. It's defo going to be easier just to assemble the wheels as is, seal them up, and check them periodically to see if there's any movement or loosening of the fasteners, than it will be to remove it though.
    • Hello, I got my wheels powder coated and they've powder coated bloody everything the mating surface and hub (even told them not to lol) anyway should I leave it or remove it. (Would be very hard) I've searched a lot and lots of powder coaters don't mask the mating surface but do mask the hub surface. How bad it powder coat on the mating surface or hub? My question is what should I do?
×
×
  • Create New...