Jump to content
SAU Community

Osaka Auto Messe


Elmo_Chic
 Share

Recommended Posts

Sptted this very creative boot lid on Auto Gallery:

bootlid.jpg

Personally I think the rest of the car is overdone, and the aerodynamic qualities of the bootlid are questionable, but it's different I'll give it that.

Link to comment
Share on other sites

Where are all the big Kansai tuners? Autoselect, Stillway, Nams etc

Just more and more crap bling bling just like TAS.

stillway are too busy tuning my car :D

I was disappointed by the lack of a fujita engineering stand. And poor old amemiya were tucked away in a corner (and only had an rx8 and their greddy FD).

I walked into hall 1 and was happy to see the two FDs sitting there, but after that, it was distinctly downhill. Halls 6a and 6b made it somewhat worthwhile - I went to those last, and I was starting to get really concerned before that!

Link to comment
Share on other sites

stillway are too busy tuning my car  :P

I was disappointed by the lack of a fujita engineering stand.  And poor old amemiya were tucked away in a corner (and only had an rx8 and their greddy FD).

I walked into hall 1 and was happy to see the two FDs sitting there, but after that, it was distinctly downhill.  Halls 6a and 6b made it somewhat worthwhile - I went to those last, and I was starting to get really concerned before that!

Stillway......going big hp or ?

Link to comment
Share on other sites

Stillway......going big hp or ?

nah, I can't go big hp at the moment - restricted to 330-340hp due to factory pump. I'll be shooting for 360+ later in the year (unless the urge for aesthetic add-ons overwhelms me, which it may well...).

What was the story behind that?

basically, if you're going to use an expensive amemiya bumper, don't combine it with cheap-arse 'widebody' fenders

oas06_6.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Little more work!  Did some body work on the rear wheel arches and since the paint was a cheap spray job before figured I’d do something to tide me over until I wrap the car.    Colour might not be everyone’s choice but I like it and it’s only temporary, just hate having primer from the wheel arches standing out.    Keeping an eye out for a decent set of wheels to throw on now. Wheels and tires on the car are junk
    • Its likely to be 70% road 30% track usage, track usage will increase if anything. Decided not to fit it as I cant be arsed changing the bushes on my LCAs again 🤣 I did get the below back from GKTech though so they should work together     The anti-squat kit and roll center adjusters work independently since they change the rear lower control arm's angle in different ways. The anti-squat kit adjusts the angle from front to back, which impacts anti-squat values. Roll center adjusters change the angle side to side, mainly to correct geometry on cars that are significantly lowered. They might affect each other a tiny bit, but overall, you can think of them as separate.
    • What are you doing with the car? street car or race car? People get hung up on the squat of the s/r chassis rears. There is positives to the squat if a car is setup and driven correctly for it (correct ride height, spring rate, alignment, damper valving). Generally just lengthen the rear traction arm by 5-10mm and that will help the squat and bump steer too. You are also correct with the roll centre too. This too also needs to be adjustable if you start messing with suspension geometry.   Having done quiet a bit of testing on race cars this year in regards to rear squat, I've seen some big positives from it in regards to drive off corners and traction. 
    • I find I am using the MX5 for everything except long overnight cruises with Jackie, or, if picking up the kids to go somewhere, the SS has so much more room inside, and is much more comfortable if your going to be doing Hwy driving for 6-8 hours And the MX5 isn't bad in stop go traffic for a manual transmission car, whilst the clutch kit has been upgraded from stock, it is still light, and also not having a stupidly light flywheel in it helps as well, I've spent alot of time sitting on the M5, M4 and M7 stuck in traffic when plodding around the Greater Sydney Region in it Another benefit is MX5's are not really a car that gets stolen, you can pretty much park it anywhere, and it will still be there when you return
    • I can totally get why you like it for that sort of commute. I was thinking BoganDore because it's such a lazy drive, for things like stop start traffic.   I used to do over an hour in stop start shit from one side of Bris to the next, twice a day. My choice of car was larger displacement, with an auto. Basically for torque in low rpm/very low speed, and no clutch pedal. But loved a fun manual for the weekends, which the partner has (plus had the LandCruiser too for other fun drives). I now have an EV as a work car, and I tell ya what, ultimate daily driver, especially if youre out of energy, like I often am after work. I don't even need to touch the brake pedal   That said, I'm presently rebuilding the Liberty GTB to get it setup for weekend drives and track abuse! So small high revving turbo engine with 6 speed cog swapper!   But for your style of commute, I'd probably take the MX5 too!   For those choices, I'm ignoring fuel economy. Because I know how atrocious V8 daily life is for fuel from when I used to daily a manual SS, ha ha. Hence why I know I love the daily rumble of a V8
×
×
  • Create New...