Jump to content
SAU Community

Recommended Posts

It will be near impossible to remove it completely. I rented a place before with a really stuffed up driveway. Everytime I drove up the driveway, my inside wheel would spin. After about 8 months, there was a pretty thick tyre track on the ground.

We tried petrol, kero, turps, everything. We tried scrubbing it with the chemicals mentioned above. We tried applying the above chemicals, then lighting them on fire. We tried using a gas cylinder as a flamer to try and burn it off.

While all these made it better, it was still quick noticeable.

Just paint over it and be done with it.

yeah ive had the same problem at a place i rented ages ago. i found using a wire brush and a heap of washing powder (nappy san or similar). Have ya tried a pressue washer/gurney, or HCL over the marks, if that doesnt work then ur probally screwed. ;)

god. i read you post and i PMSL ;)

anyhoo citroclean is agressive as. it removes polish off the floor so it should make a dent in it at least. try a few application of it to remove it. ie put it on and attack with a stiff brush, wait a little then put more on and attack it again.

anyone tried CLR?

if all else fails buy some grey paint lol

Your local auto parts supplier should have a range of concrete cleaning products.

I used one a while ago, very caustic stuff, did a good job of removing oil stains, but I don't know how it would go with rubber. (I guess essentially they're the same compound?)

Hose the area, dump the powder on, scrub it, let it sit a bit, then hose it off.

But if you're going to use anything like that, suit up well.. it burned little pitted holes into my leather work boots.

I used one a while ago, very caustic stuff, did a good job of removing oil stains, but I don't know how it would go with rubber. (I guess essentially they're the same compound?)

Theoretically yeah, they're both hydrocarbons. Which means they should both react (to a certain extent) to other hydrocarbons, especially volatile liquid ones (kerosene or petroleum solvents).

I still pity the fool that shits in his own backyard.

I still pity the fool that shits in his own backyard.

God invented rental properties so that people could shit in their own backyard, then move along to the next place when the shit can is full :D

Be mindful with whatever you're using that it's possible that anything that would dissolve the rubber by making it softer is likely to sink into the concrete (especially if it's really porous).

Obviously if whatever you're using eats all of it away that's fine, but sometimes chemicals tend to do a half assed job.

alternatively... soak your tyres in diesel, then proceed to drive up and down the driveway evenly.

then give the landlord a bill for treating the driveway with waterproofing silicone.

i used to work at Golden Circle, and they got this stuff that'll burn the skin clean off your hands...

wen u squeeze the peel of an orange u get this acidic juice... they process the stuff into wat Golden Circle call "citrus oil"

if you can find that, u got no worries

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It's about the same time for me from Bunnings, or the Fasteners. My big push away from takeaway food, and gluten in general keeps me away from the Bunnings Snags too! Weather up here, I've been out for two walks today in the beautiful sunshine. Had a few little drizzles, and some wind, that honestly, a tin of beans and I could compete on how harsh she blows Thankfully, being this bit inland, we're not getting anything much really. Will probably pick up a bit more when/if Cyclone Alfie decides to come ashore. A few areas in the GC though, and south into NSW are really getting smashed though! Right now, I'm just annoyed Alfie hasn't hit, as I'm not allowed to crack into the BBQ foods like the bacon and eggs until the Cyclone hits "In case we lose power"...
    • I love fastener joints, the price difference between them and joints like Bunnings or Super Cheap is amazing, and they either have exactly what you want, or they can get it to quick They have even given me some for free when I only needed a couple of specific size In saying this, I have paid premium for fasteners from Bunnings if they have the sizes I need, but only for convenience really, as my local is only 10 minutes away, the Sushi joint near them is also a consideration  How's the weather Matt? Stay safe mate
    • Wideband is worth setting up if only for tuning purposes. I would not mess with the ignition system unless there's a misfire. HKS crank trigger is popular out here for the relatively easily sourced Denso crank sensor, not a bad idea to install as well regardless of power level on a standalone. Boost leak test is worth thinking about. Oil pressure sensor tied to a fuel cut isn't a bad idea either. Getting the tune figured out is a good idea. Without putting eyes on it and getting under it there's no way for us to tell you exactly what it needs but most likely you're down to the last 10% that will make a big, big difference in how happy you are with the car.
    • Doing a refresh of my 33 and can see a few websites stating they sell the entire main carpet for our cars, but they all have generic photos which is fine, i understand they are custom made to order.  Just seeing if anyone has got it done or had any experience with this, as i would only want to do it if the fit and finish was as good as oem https://carmatsdirect.com.au/products/moulded-carpet-or-vinyl-for-nissan-skyline-r33-1993-1998-coupe https://knoxautocarpets.com.au/moulded-carpets/nissan/skyline/skyline-r-33-1993-1998/
    • Any plans for E85? If so, add flex fuel sensor.   I'd probably add in the sensors I mentioned above if the Link will support using them for engine protection. With water pressure, you need to be able to effectively set it that "If temp > X, and pressure = atmospheric, shutdown" as at running temp, you should be able to read pressure in the cooling system. If pressure suddenly disappears, it means the water went some where, and this is a quicker reaction than waiting on water temp to go up (Which, can take a little longer than you'd like, considering it now has to wait for hot air to heat it up) Oil pressure, Oil temp, both would be on my list too if you're looking to add sensors. Wideband O2. And at least one EGT sensor. If you're feeling deluxe, put in individual runner EGTs. Single EGT sensor is more so forget about a specific number, get used to "What is normal EGTs", and then keep an eye on it, if it starts going away from "normal" it's a sign something is wrong (Also, things like the tune can still start going out of spec, but EGTs may not show it, for example one injector starts running leaning, so ECU richens everything up, now 5 out of 6 cylinders are rich, and running cool, with one cylinder lean and running hotter, so it's not perfect) Then there is your other things to look at non sensor related, but you may have already done, or have underway, and that would be things like building a sump for more oil, and better oil control under high G-Forces (Cornering, brakes, acceleration). Basically, the above is worth looking/thinking about, if the ECU can do protective stuff with it, and you continue to use it how you are (Drive it to the track, thrash it, drive home, repeat once every 3 to 4 months)
×
×
  • Create New...