Jump to content
SAU Community

Recommended Posts

Item: BNR32 GTR 1994 Model

Location:Brisbane East

Item Condition: 102,000km's VGC

Reason for Selling: Owned for 2.5 years, time to move on to next project

Price and Payment Conditions: $29,000 ono

Extra Info:

- CES dump pipes

- Jasma aftermarket front pipes

- Walker 3 inch cat

- Jasma 3.5 inch cat back exhaust

- RB20DET 80mm AFM's

- Apexi super suction pod filter kit

- Sard 550cc injectors

- Apexi Power FC with hand controller

- Power Enterprise boost gauge controller

- Urethane bushes upper and lower front done 18 months ago

- Rear aluminium cradles fitted same times as front bushes

- 18 inch Lowenhart wheels with brand new 235/40 Dunlop Sport 3000A tyres

- Brand new heavy duty single plate clutch

- Eclipse head unit with Pioneer three way fronts and 6 inch Hertz three way rears

- Momo Competizone gear knob

- Recently had TPS, Neutral switch, fuel pressure regulator and rocker cover gaskets replaced.

This car is very clean and reliable, hasn't missed a beat in two years of ownership. Came with the aftermarket exhaust when i bought it, other modifications have been done in the last three months. This is a very quick car, but aren't all GTR's!

With just the exhaust modifications it dyno'd 320HP at the rears. Car is serviced every 5000km's by Andrew Chapman (Chapman & Chapman).

Contact Details: Sean - 0414 266 477

post-15674-1140495327.jpgpost-15674-1140495284.jpgpost-15674-1140495545.jpg

Link to comment
https://www.sau.com.au/forums/topic/106732-bnr32-gtr-1994-silver/
Share on other sites

i got a s14 series 2 98 model,

fresh cherry black respray and 19 inch simmons

ran flat 13 sec... i have the time slips

consistent 13.1 13.2

only mods is exhaust fmic and boost...

88,000 kms

immac in and out....

will swap but no cash adjustment

Edited by den001
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I’m hosting a bunch of execs in the McLaren box on Saturday. If you’re around I’ll come say hi, and see if I can sneak out some freebies.
    • Yes. All of this. But even when you get the NOx as low as you can go on an RB, it will no doubt still be way too high. Same with CO and HCs. The tech and the tuning time just isn't there.
    • Dang. I love the little 'oil used' bingo card on the side.   🤣  Well, now they can use a box and an oil-filled goon.
    • Many many moons ago, I was chatting with Andy Wyatt, about his auto ignition tuning. One of the HUGE things he said to me, when tuning for power, right where you hit peak ignition timing for your max torque, dramatically increases NOx emissions. He was finding in testing, particularly on engines you could advance timing beyond peak torque, that backing the ignition timing off a couple of degrees only made for a small drop in torque (compared to if you keep backing it off further the same amount of degrees) but dramatically reduced NOx emissions. I'd say targetting for 14.7, and he's even mentioned in some scenarios going slightly leaner, and pulling a few degrees of IGN timing will help pass for emissions quite a lot. However, who tunes an RB for emissions
    • The main stuff from.Vibrant I see is more their intercooler piping, and everyone raving about their clamps, but when I looked it was about $150 per clamp... I was a bit   I also thought the public price SP had up was high. As Mark said, a normal exhaust shop can fab them. It was many years ago that I had a full exhaust built, but for a full turbo back exhaust, and 2 custom built mufflers, plus a high flow cat, was about $1,100, and that was fully installed, drive in, drive out. I believe SP was about $900 for 2 mufflers, just supplied   These days, I just buy the material and built it myself, because I need to stretch my $$$
×
×
  • Create New...