Jump to content
SAU Community

Recommended Posts

You can check out M2000. They've got a few imports for rental including the 350z. But as these are considered performance cars, if i'm not wrong, there's an age limit to the car. Something like you can't be below 24 or 25 i think?

Link to comment
https://www.sau.com.au/forums/topic/111540-350z-car-hire/#findComment-2057277
Share on other sites

$200 is very good considering the shit it would get in the national drift comp, comming up next month

Just make sure you take the extra insurance option.

hahhahahaha

I mate had one hired for him for his b/day, yeh, they bounce limiter and make tyre smoke...

Link to comment
https://www.sau.com.au/forums/topic/111540-350z-car-hire/#findComment-2065590
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Does your rb gearbox have the common input shaft bearing sound? (One one where it goes away when u push the clutch in or get to higher revs) I heard if you put the wrong oil it can get this sound.
    • There's more than one way to skin that cat, and most of the sump Maatouks have done will be GTR sumps. They are HUGE in GTR drag racing here.
    • Yeah...I always start at the shift solenoids, because there's only a few reasons these will spook into limp mode, and bad shift solenoids is one ~ the other can be the shift control module (if you have steering wheel shift buttons)...it's easier to eliminate the solenoids first.
    • Might piggy back off this thread since there's been a good discussion about PWM.   I purchased a Walbro 460 F90000267 and have been looking into PWM to understand it. It was purchased more of a future proof as my original OEM fuel pump died (r33 below 200kw) and figured I'd just upgrade it to this. That's when it hit me that a pump this big can cause more dramas with such high amperage draw and heating of the fuel pump being on 100% all the time in such a mild setup.   I have a Nexus R3 and slowly collecting power mods but I was looking into the PWM feature on the NSP software:   Then looking at the graph from the fuel pump:     Am I safe to assume reducing duty cycle to 50% for example would make the pump run like a 230/lph ? Where does the PWM come in all of this ?   I've gone down the rabbit hole of PWM fuel pumps and it seems there are many differing opinions on how to go about it 😅  
    • Thank you, this will keep me busy for a bit.  I will update progression.
×
×
  • Create New...