Jump to content
SAU Community

Restrucuring Of Ice Performance

Leewah

By Leewah,
in Victoria

 Share

Recommended Posts

Leewah Veteran

Leewah

Posted
  • Author
Posted

NFI Jack, I just copied snowcone's address from the thread in the events section :P Blame the Pres!!

Shouldn't that be 'Bricker' Street instaed of 'Bricket'????

RPMZ Jack, I'll give G a kick in the pants to get this sh|te happeneing. I think he's gonna hold off factory shoots until the refurbishment in the factory is complete and the place has been tidied up.

Of course, as the 2 workshops are so close to each other, there will naturally be some competition however there will still be a fair bit of referral work going on. Make it be known now that this IS an amicable split. There have been no fights, no heated words, not even a GAGF spoken. There IS NOTHING bad going on behind the scenes.

Racingline Rising Star

Racingline

Posted
Posted

Hi guys,

I just wanted to confirm all the above info regarding my move to Racingline Motorsport.

We will be up and running in the week of the 1st of may, so for any info or advice please dont hesitate to call my mobile listed below, as we dont have a land line yet.

I will post a new thread including our range of services etc once we are fully setup.

cheers.

Nigel.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • kevboost7
      One Headlight isn't working - Driver Side Fuse Keeps blowing

      By kevboost7 · Posted

      I figured out what’s wrong. It’s something to do with the high beam wire short circuiting. When I measure the continuity with a multimeter on the headlight socket connector it gives me a continuous beeping noise when I put it on the ground socket and also on the high beam socket.  On the passenger side of the car (working side), it’s only beeping when the probe is on the ground socket. Which makes sense.  So that means it has something to do with the high beam power supply for the drivers side. How do I trace that? Is it the turn signal lever malfunctioning? The one that also controls the high beam and low beams. 
    • Bncr33nokout
      Hey lads just a fellow gtr owner

      By Bncr33nokout · Posted

      Hey lads just finished tidying up a gtr a bought. Originally from Sydney now living in New Zealand 
    • slamaa
      R33 GTR/GTS25T Rear Trunk Finisher Panel, 2-Door Models

      By slamaa · Posted

      Hi Guys, Looking for this piece if anyone can help out.   https://tfaspeed.com/products/nissan-skyline-r33-gtr-rear-trunk-finsher-panel
    • Thatjuan
      Nissan Gloria Hy34 issues

      By Thatjuan · Posted

      How did you go with your problem? End up fixing it. Have a y34 aswell vq30det
    • EndZee
      Weird compression after rebuild

      By EndZee · Posted

      But if I smoke test 5th cylinder it’s all ok, no leaks  when I try with 2nd it’s leaking exhaust and intake, it doesn’t come from oil dip stick.    so maybe when car was running poorly, rich or sth. Spark plugs were black and covered in charcoal or sth lookalike. could potential contamination make valves not seal properly? is there also a possibility that rb’s don’t have equal performing cooling passages  meaning back of the engine will be hotter than front. Can this cause improper wear if engine was running under load for short time? Or carbon build up could just burnt from 4-6 and is still on 1-3?   I out of my head like really. Timing is as manual crank-exhaust 47, exhaust-intake 38 at this point I thinking about give it a try and make another 500-1000km and check if anything change, if not I will most likely disassemble engine head /or whole engine and send it back to rebuild. It’s killing me     
×
×
  • Create New...