Jump to content
SAU Community

Recommended Posts

don't worry, r32 oil pressure gauges are often faulty and read wrong.

Every R32 i've seen including mine either reads wrong or just doesn't move at all, and i've checked heaps :bunny:

You only have to worry if the little red light comes on :D

Link to comment
https://www.sau.com.au/forums/topic/113699-no-oil-pressure/#findComment-2095488
Share on other sites

its not the actual gauge. its the oil pressure switch. get it changed soon or go get an aftermarket oil pressure gauge which comes with its own oil pressure sender which replaces the standard one.

this is a common problem with 32's.

Link to comment
https://www.sau.com.au/forums/topic/113699-no-oil-pressure/#findComment-2095843
Share on other sites

i had the same kinda thing on my r33 recently.. once the car was pretty hot the gauge would randomly show it at 1psi for a while.. i soaked the electrical connector on the back of the oil sender in contact cleaner and it hasnt stuffed up since..

I think in my case though i had spilt heaps of oil on it when i took the oil filter off last time :(

Link to comment
https://www.sau.com.au/forums/topic/113699-no-oil-pressure/#findComment-2096016
Share on other sites

The sender is quite easy to remove.. get a 17mm spanner on there, and unscrew from behind.. if you jack that side of the car up, it shouldn't leak any oil out the block.

Screw in new or replacement sender. Probably best off with an aftermarket gauge when you're there.

Link to comment
https://www.sau.com.au/forums/topic/113699-no-oil-pressure/#findComment-2097526
Share on other sites

Yeah mine just stays below 4 all the time, good to know this is common and not much to worry about :(

i'd still go and get your sender replaced to make sure. its not something you want to take a gamble on.

justjap sell oil pressure gauges which include the sender in the pack for $50. cheap insurance if you ask me... very cheap.

Link to comment
https://www.sau.com.au/forums/topic/113699-no-oil-pressure/#findComment-2099646
Share on other sites

  • 2 weeks later...
in my 32 gauge reads about 4 on start up and once warm reads almost 0 then 0. been told to replace oil pressure sender, yeah common problem.

Mine used to be fine, alway on 4 or just under, Last week i noticed that when i start the car it reads about 4 and once warm reads almost 0. Same as yours. I think i might get a oil pressure gadge and test it out next week.

Link to comment
https://www.sau.com.au/forums/topic/113699-no-oil-pressure/#findComment-2130056
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, the other thing I've sorted is a baseline dyno run up at Unigroup's new location. The auto trans was a little unco-operative by both shifting down when the throttle was floored on the dyno (so Mark had to ramp it up more slowly than in a manual) and also by shifting up at 6,000 even in sports mode instead of the indicated redline of 7,000 Still, on a hot day it made 240rwkw at 16psi which seems about right for 300kw (400hp) through an auto at the wheels.  The shape of the curve is not quite right because it was not full throttle to about 4,500 to stop it kicking down, but until I can get a tune on the auto trans control this was the best we could do.....full boost will be well below 5,000 once that is sorted, I'll get some data logs when I can to confirm For comparison, the R32 made 255 at 12psi (at 4,500) on the same dyno with tune, n1 turbos, cam gears, big exhaust but otherwise all standard so the v37 is likely a little better out of the box. One thing that is very clear is that the standard water to air intercoolers are not up to sustained use at full throttle in warm ambient temps. After about 5 runs (so only a few minutes full throttle), it was pulling boost and timing and dropping 10-15% power. Unfortunately I didn't get that printout and the Unigroup guys are away at the moment, will try and get hold of it on their return. So, looks like a healthy engine to start modifying and the only real area of concern is the w2a heat exchangers which the aftermarket has plenty of solutions for    
    • I maintain it actually looked really nice in person. So much so that I thought "No, this is illegal" but there it was, clear as day. I think we can easily call the wing and wheels/height to be transformative. Not saying it's better than the GR Whatever, or the 86, or the WRX STI or anything of that sort (the internet says it all bolts up so you can buy best of all worlds?) but it's still at least a thing and not nearly AS bad as people say.
    • That's less offensive than the previous gen.....except for all that ugly black tupperware around the edges. Blerck!
    • I leant out the window recently and took a picture of this new WRX. It looked real damn fine in person. It's faster around a track (stock) than a (stock) GR Yaris. It's much more practical despite being heavier. It's significantly cheaper. This gen tunes really well, much better than others. .... I think they're probably a lot better than people expect.
    • WRXs are a pure pleb boring car these days. You need to get an STI to even get close to what a WRX used to be.
×
×
  • Create New...