Jump to content
SAU Community

Rb25det Slave Cylinder Same As.....?

DRFT 14
 Share

Recommended Posts

DRFT 14 Collaborator

DRFT 14

Posted
Posted

I just spent the better part of this morning calling around for an RB25DET Slave Cylinder I need for my 25t S14 Silvia conversion. I rang all the major automotive chains here in NZ and no one has a listing for RB25DET slave cylinders, only Rb20. The S14 slave fit perfectly on my old RB20 conversion but the 25t gearbox seems to have the bolt holes in a different place.

My question is, are there any other Nissan gearboxes that share the same slave as the RB25DET? I used a Z32 driveshaft yoke for my 25t gearbox so im hoping I can do a similar thing with the slave cylinder?

Damn RB25DET gear is always hard to find :D

Link to comment
https://www.sau.com.au/forums/topic/114355-rb25det-slave-cylinder-same-as/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • myrbgivesmeheadaches
      Ticking Sound On Idle - Rb25

      By myrbgivesmeheadaches · Posted

      Sorry for reviving an old post, but I'm having the same hot idle tick issue. Did anyone ever find out what it was?  I have checked/ replaced Injectors Coils checked Lifter clerance (is at zero) Checked Cam lobes Replaced exhaust gasket and studs Would appreciate any advice this is driving me nuts  
    • MBS206
      NC MX5

      By MBS206 · Posted

      There's a huge reason manufacturers are tuning in dead flat torque curves... Make them reliable (and more drive able)
    • GTSBoy
      AC not coming from top vents

      By GTSBoy · Posted

      What HVAC actuator is under the steering wheel? Do you mean on the RHS of the centre console, immediately to the left of your shin? If so, then yes, it is probably that one, because that is the mode door actuator, and from what I know, it's still a pain in the arse to replace. I don't know about whole dash out, but you certainly have to rip into the centre console section. I don't know if it's covered in the workshop manual, as I haven't spent much time looking at those parts of it. (and by "the workshop manual, I mean the R32 GTR one, which is the most comprehensive one we have, and it should be similar enough between that and later cars to serve as a guide).
    • dbm7
      Shifting questions

      By dbm7 · Posted

      ...oops. forgot the TCU end...
    • Sleepergm
      Custom titanium intake

      By Sleepergm · Posted

      No I got mine from a friend that had fabricated one … but I had to fit it to my setup which was a hks turbo setup. His was a Garrett -7. So one of my turbos was not a flange for one side … then I had a leak in the welds I had to find a weld shut … in the end the setup was decent priced but I spent a lot to get it fitted. A couple companies I checked would make it but you’re talking 7-9k aud with titanium. No joke mine was 6-7k even second hand after I had to fit it in Hong Kong … labour is expensive here. 
×
×
  • Create New...