Jump to content
SAU Community

Recommended Posts

I have received emails asking if my car is an Rz or Rzs.Its definataley an Rz.

It has the factory big brakes(4pot front,2pot rear) and the recaros were factory fitted.It currently has 87,000kms as is usually only driven weekends

Thanks :huh:

Edited by Zaia
Have u run the 1/4 yet, if so what were the times?

Best time was a 12.5 with lots of wheel spin on 19" street tyres(pictured) and best mph was 123 so the car should be good for a high 10 or very low 11's with sticky street rubber

Edited by Zaia

This car is very very nice, clean and quick (I was with him the night at the drag strips). A very sensible bloke too. You will never go back to a skyline once you ride in one of these beasts!

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok awesome! I’m not running a aac/iacv (although I do have the r34 iacv but I’m running the heater core loop. I’m running the chase bays booster delete so In that case would I need to block off those posts? So at the moment I need to run from one of the posts to the fpr and then a separate post to the boost controller then to the wastegate? Also I’m assuming that each port has a specific use like the first one farthest to the left would be (for example) manifold to fpr and then second would be to boost controller?
    • I was just going through this on Neil's car (33 gtst). Assuming you are using standard AAC and Cold start valves, you need Post Turbo Pre throttle to Boost Controller (if you have one) then to Turbo Wastegate Pre throttle to AAC input AAC input T piece to Cold start input Cold start output to plenum post throttle AAC Output to plenum post throttle AAC Output to brake booster (needs a 1 way valve) Plenum post throttle to Fuel Pressure Regulator Plenum post throttle to Blow off valve signal Plenum post throttle to Boost controller input (if you have one)
    • I’m trying to figure out the purpose of these fittings. Assuming they’re for coolant but not sure where the lead to. I know the bigger one on the right (which isn’t filled) is the brake booster. If anyone has a photo of a diagram of this intake or has a set of instructions it’d be greatly appreciated 
    • How much is that r32? Is that $170k or $1.7m 
    • Ahhh! My silly brain was thinking Nissan started selling them straight away, but they waited w or three years didn't they?   Maybe Duncan should build an R35 race car over the V37... There's a cheap yellow one on car sales Duncan, would only need your splash of purple added...
×
×
  • Create New...